Table of Contents
Advertisement
ASSEMBLY AND INSTALLATION
BEFORE YOU GET STARTED
Spread cushioning flat to lay the TV on. This will help to prevent damage.
1. Stand assembly
a. Attach first stand to base of TV, ensuring R and L stands are on correct
side. You can install either one first.
b. Insert three 18mm screws and use Phillips head screwdriver
(not supplied) to tighten.
c. Repeat these steps for second stand.
2. Connect to antenna
a. Connect an antenna cable (not supplied) via the 'ANT' input port at the
back of the TV.
b. Ensure the antenna cable is also connected to a working antenna, either
via an antenna wall socket in your home, or directly.
3. Turning TV on
a. Plug the power cord into a suitable power outlet. The standby will display
a light, showing that the TV is receiving power.
b. Press the POWER ( ) button (either on your remote control or the lower
side of the back panel on the TV – see page 8) to turn the TV on. The
TURNING TV OFF
POWER ( )
Press the
button on the remote control to enter standby mode.
To power down the TV completely, unplug the power cord from the power
outlet.
Do not leave your set in standby mode for long periods of time. If you will not
use the TV for a long time, it is recommended to unplug the set from both the
power outlet and aerial.
Red light on
3a
Standby mode
3b
TV on
6
Advertisement
Table of Contents
