Panasonic ER-GC20 Operating Instructions Manual page 12

Cleaning
Cleaning the clipper using the sliding
plate for maintenance
Rinsing
The mark on the left means suitable for
cleaning under an open water tap.
Warning
Disconnect the power cord from the clipper before
cleaning it in water to prevent electric shock.
1. Disconnect the AC adaptor from a
household outlet.
2. Disconnect the power cord from the
clipper.
3. Remove the comb attachment.
4. Slide the sliding plate for maintenance
until it clicks.
5. Hold the clipper upside down and shake it gently
or flick off the hair trimmings with your fingers.
6. Run water down the opening of the
sliding plate for maintenance and rinse
off any hair trimmings.
• Water will be discharged from the water
drain hole.
12
7. Gently shake the clipper 4 or 5 times and then
wipe off any water drops from the clipper and the
blade.
8. Place the clipper on a towel with the power
switch on the main body facing upwards.
9. Keep the sliding plate for maintenance opened to
let it dry fully.
Cleaning with brush
1. Disconnect the AC adaptor from a
household outlet.
2. Disconnect the power cord from the
clipper.
3. Remove the comb attachment.
4. Slide the sliding plate for maintenance
until it clicks.
5. Use the supplied cleaning brush to
brush off hair trimmings.
• If you cannot remove all the hair trimmings,
clean with the sliding plate for maintenance
opened and blades removed.
Note
• Power will not turn on while the sliding plate for
maintenance is open.
• If the power switch is turned on, the sliding plate for
maintenance cannot be opened.