Getting Started - Initial Set Up - Technika LED19-251 User Manual

Getting Started - Initial Set Up

GETTING STARTED  INITIAL SET UP
1) Using the RF cable supplied, connect the TV
to the TV Aerial wall socket (Fig A)
4) You will now be welcomed with the initial
set-up screen.
If it does not appear, on the remote control,
please press [MENU] then 8-8-8-8 and the
menu will appear.
Press OK on the remote control and tuning
will start.
If you are missing channels, the reason for this is likely to be signal strength, you should
consider connecting signal booster and re-tuning the TV.
As part of our ongoing development to reduce power consumption, we have added an extra function to this Television
called 'Ecohome' (you will see this during the fi rst time installation set up). Power consumption using the Ecohome
function is approximately 15% lower than some other modes. The picture brightness is reduced using the Ecohome
function. If this function is not suitable for your viewing environment, you can select other modes as necessary. (Please
note, 'Professional' mode is for optimum default picture settings, however, power consumption is approximately 15%
higher than 'Ecohome' mode)
Please refer to the user guide section 'Picture settings' in order to change the mode to one that maybe more suitable for
your environment. There is also a shortcut button on the remote control called 'P-Mode' should you wish to change to
another mode.
Fig A
3) Insert the batteries supplied into the
Remote control and press the Standby
button to power on the TV
2) Connect the power cable to the Electrical
outlet (Fig B)
Fig B
5) After tuning the following screen will
appear.
11 11