Advertisement
Quick Links
Advertisement
Related Manuals for FP FPi 1015
Summary of Contents for FP FPi 1015
- Page 1 11/2022 FPi 1015 Inserting System Quick Install Guide...
- Page 2 Your machine may not have some of the features described in this book. Francotyp-Postalia GmbH Prenzlauer Promenade 28 · 13089 Berlin (Germany) Freecall: +49 800 372 62 68 info@francotyp.com · fp-francotyp.com...
- Page 3 The FPi 1000 can be supplied in the following variants: • FPi 1010 • FPi 1020 • FPi 1015 • FPi 1025 Follow the instructions in this guide to get your FPi 1000 system setup and running. Included in this guide are instructions for the following: •...
- Page 4 Quick Install Guide Step 1: Unpack 1. Lift out the following accessories and put them to one side: • Test paper and envelopes • Power Cord 2. Remove the cardboard and foam packing. Francotyp-Postalia GmbH | FPi 1000 | P-FPXxXxx_EN; Rev. 00 11/2022...
-
Page 5: Safety Notice
Quick Install Guide Step 2: Set in Place 1. Lift the inserter by its handles and place it on a flat surface. SAFETY NOTICE! • Lift the inserter only by its lifting handles • Lift correctly (bend knees and keep back straight) •... - Page 6 Quick Install Guide Step 3: Connect and Turn On 1. Connect the power cord. 2. Switch the power ON. (The power switch is on the back panel next to the power cord.) After a few seconds, the display shows READY. SAFETY NOTICE! •...
-
Page 7: Step 4: Change Display Language
Quick Install Guide Step 4: Change Display Language 1. Turn the machine on and at the same time press and hold the no and yes keys on the control panel. The word Password appears. 2. Press the no key until 99 appears. (If you scroll past 99, press the yes key to scroll back.) Password Password... - Page 8 Step 5: Check the Moistener 1. Slide the moistener tray open. 2. Fill the moistener with water or FP seal-IT. 3. Slide the moistener tray closed. NOTE: It takes about five minutes for the moistener to get fully wet and ready for use.
-
Page 9: Step 6: Load Envelopes
Quick Install Guide Step 6: Load Envelopes Use the test paper and envelopes to practice using the system and to make sure that system is working correctly. 1. Fan test envelopes marked with the letter B. 2. Tap the stack of envelopes to align edges. - Page 10 Quick Install Guide Step 7: Load Sheets 1. Fan the stack of sheets test sheets that are marked with A1. 2. Tap the stack to align the edges. 3. Place the stack of sheets in feeder A1, FACE DOWN and BOTTOM EDGE FIRST.
- Page 11 Quick Install Guide Step 8: Setup The selection keys on the control panel enable you to turn feeders and job options on and off. Pressing the keys repeatedly scrolls through the options available on your system. When you have made a selection, the associated LED indicator on the control panel turns green.
- Page 12 Quick Install Guide Step 9: Run a Test Piece 1. Press the Trial Piece button. 2. If the trail piece checks out ok, press Start. 3. Press Stop to stop processing. NOTE: The trial piece will not be sealed so you can check the contents of the envelope.
- Page 13 Quick Install Guide Step 10: Congratulations Your FPi 1000 is now ready to use. There is a slot on the top right side of the cover (shown in the image here) to store the FPi 1000 Operator Guide. This guide explains how to use your new system. If you experience any problems installing your equipment, please refer to the "Troubleshooting"...
- Page 14 Declaration of Conformity The Declaration of Conformity of the original manufacturer shown on the following page is therefore fully applicable to the product(s) described here. Francotyp-Postalia GmbH | FPi 1000 | P-FPXxXxx_EN; Rev. 00 11/2022...
- Page 15 Declaration of Conformity DECLARATION OF CONFORMITY (En) DÉCLARATION DE CONFORMITÉ (Fr) KONFORMITÄTSERKLÄRUNG (De) DICHIARAZIONE DI CONFORMITÀ (It) FÖRSÄKRAN OM ÖVERENSSTÄMMELSE (Sw) SAMSVARSERKLÆRING (Nor) U.S.A. Pitney Bowes, Inc. Pitney Bowes Deutschland GmbH 3001 Summer street Poststr. 4-6 Stamford, CT 06926 64293 Darmstadt U.S.A.
- Page 16 Francotyp-Postalia GmbH Prenzlauer Promenade 28 · 13089 Berlin (Germany) Freecall: +49 800 372 62 68 info@francotyp.com · fp-francotyp.com...
Need help?
Do you have a question about the FPi 1015 and is the answer not in the manual?
Questions and answers