Lock Testing - Digilock Curve Keypad Basic Install Manual

LOCK TESTING INSTRUCTIONS
To ensure functionality after installation, it is recommended that the lock is tested with the door open�
For keypad locks with deadbolt rear units:
Press to extend the bolt.
= `
Press again to retract the bolt.
= `
For keypad locks with deadlatch rear units:
Press to retract the latch.
= `
The latch will extend automatically.
Repeat test with the door closed.
If ten rapid beeps are heard, the strike plate or door alignment may need adjustment to allow the lock to operate properly.
If the door does not lock when the bolt/latch is extended, the strike plate or lock position may need adjustment.
12
I NSTALL GU ID E
Keypad & RFID | Basic & Advanced
For touch-free RFID locks with deadbolt rear units:
Present any RFID card to reader to extend the bolt.
Present the same RFID card to reader again to retract the bolt.
For touch-free RFID locks with deadlatch rear units:
Present any RFID card to reader to retract the latch.
The latch will extend automatically.