Table of Contents
Advertisement
Installing Polishing Pads/Bonnets
1. To install, remove the battery pack and place the
tool on its tool rest with the backing plate upright.
2. Press the polishing pad/bonnet securely onto the
backing plate. Use a centering tool, if provided, to
ensure the pad is aligned for proper balance.
3. To uninstall, remove the battery pack and reverse
the procedure.
Polishing pad
Backing plate
OPERATION
To reduce the risk
WARNING
wear proper eye protection marked
to comply with AS/NZS 1337.1.
When working in dusty situations, wear
appropriate respiratory protection or use a
suitable dust extraction solution.
Do not wear loose clothing or jewellery when
operating polisher. They could get caught in
moving parts causing serious injury. Keep head
away from polisher and polishing area. Hair
could be drawn into polisher causing serious
injury.
Starting, Stopping and Controlling Speed
Generally, lower speeds are recommended for tight
work areas and higher speeds are ideal for large
surface areas. Use the speed control dial to set the
maximum speed for the application.
1. Set the speed control dial to the desired maximum
speed.
2. To start
the trigger.
3. To vary the speed, increase or decrease the
pressure on the trigger. The further the trigger is
pulled, the greater the speed, up to the speed set
on the dial.
4. Use the trigger lock to LOCK ON the tool for continu-
ous use, if desired.
5. To stop the tool, release the trigger. Ensure the
tool has come to a complete stop before laying
the tool down.
Polishing
Always use the handles for proper control. Move the
polisher back and forth in long, sweeping strokes. Too
much pressure, the wrong angle or improper motion
may cause swirl marks or burning.
For detailed polishing instructions, read the instruc-
battery pack from the charger or tool before
performing any maintenance. Never disassemble
the tool, battery pack or charger. Contact a
MILWAUKEE
Keep your tool, battery pack and charger in good
repair by adopting a regular maintenance program.
Inspect your tool for issues such as undue noise,
misalignment or binding of moving parts, breakage
of parts, or any other condition that may affect the
tool operation. Return the tool, battery pack, and
charger to a MILWAUKEE
repair. After six months to one year, depending on
use, return the tool, battery pack and charger to a
MILWAUKEE
If the tool does not start or operate at full power with
a fully charged battery pack, clean the contacts on
the battery pack. If the tool still does not work
properly, return the tool, charger and battery pack,
to a MILWAUKEE
your tool, battery pack or charger in liquid or
of injury, always
Clean dust and debris from any vents. Keep tool
clean, dry and free of oil or grease. Use only mild
soap and a damp cloth to clean, since certain
cleaning agents and solvents are harmful to
plastics and other insulated parts. Some of these
include petrol, turpentine, lacquer thinner, paint
thinner, chlorinated cleaning solvents, ammonia
and household detergents containing ammonia.
Never use flammable or combustible solvents
around tools.
For repairs, return the tool, battery pack and charger
to the nearest authorised service centre.
For a complete listing of accessories, go online to
milwaukeetool.com.au / milwaukeetool.co.nz or
contact a distributor.
5
MAINTENANCE
To reduce the risk of injury, always
WARNING
unplug the charger and remove the
service facility for ALL repairs.
®
Maintaining Tool
service facility for inspection.
®
service facility for repairs.
®
To reduce the risk of personal in-
WARNING
jury and damage, never immerse
Cleaning
Repairs
ACCESSORIES
Use only recommended accesso-
WARNING
ries. Others may be hazardous.
service facility for
®
Advertisement
Table of Contents
