Optional Kit Installation - Scotsman DD40 Service Manual

SCOTSMAN FLOAT CARBONATOR
"CARB100" INSTALLATION
1. Remove from carton, inspect for freight
damage. If damaged file a claim with the
freight company immediately.
2. Locate the carbonator on a flat surface.
3. Connect the water supply to the water
"in" (3/8" male flare on pump body) Use
3/8" or larger line.
4. Connect carbonated water line from to
carbonated water "out" (on tank) to the ice
bank CO2 water "in".
5. Install CO2 regulator on CO2 tank.
6. Connect CO2 line from the high
pressure CO2 regulator to CO2 "in" fitting
on the carbonator tank.
7. Install tank disconnects on the end of
the CO2 lines.
8. Turn on CO2 tank, set the high pressure
gauge at 80-100 psi.
Set low pressure gauge at 45 psi. (Diet to
8-15 psi).
9. Check all fittings with soapy water for
possible gas leaks.
10. Turn on water to carbonator.
11. Plug electrical cord into properly
grounded 115 volt outlet.
NOTE: Grounded outlet must be used
for safety. If local codes require hard
wiring, follow these steps.
CARB 100
DD40
Optional Kits
REMOVE: Cord plug from 115 volt outlet.
Wiring compartment cover from motor.
Wire nut from power supply wire, quick
disconnect terminal from motor terminal,
and ground wire fastener.
Cord from motor.
INSTALL: Appropriate bushing into conduit
hole in motor.
Permanent wiring to motor through bushing
into wiring compartment.
One conductor to switch cord with wire nut
removed in step 3 above.
Other conductor to terminal from power
cord was removed.
Ground wire to motor housing with green
grounding screw.
Wiring compartment cover.
Purge CO2 pressure from carbonator once
or twice while filling by pulling up on
pressure relief valve on the top of the
carbonator tank.
12. Connect syrup lines from syrup tanks
to dispensing lines on ice bank (located
behind the front panel).
13. Connect gas to syrup tanks.
14. Adjust soda valves for proper mix.
15. CO2 tanks should always be secured
to prevent them from falling over.
HIGH PRESSURE
TWO LOW PRESS.
REGULATORS
February, 1988
Page 5
REGULATOR
FITTINGS
BRAIDED
HOSE
KINSDD KIT