Pre-Operation; Before You Begin; Setting Up The Appliance; Tools Required - Vissani VXWC540BSSEL Use And Care Manual

Dual zone 24 in. built-in 51-bottle wine and beverage cooler in stainless steel
Table of Contents

Advertisement

Pre-operation

BEFORE YOU BEGIN

IMPORTANT:
back or side for any length of time during this
process, it must be allowed to remain upright
for 6 hours before plugging it in to avoid
damage to the internal components.
Read instructions carefully before operating.

SETTING UP THE APPLIANCE

Two people should be used when moving the appliance.
Remove interior and exterior packaging prior to installation. Wipe the outside of the appliance with a soft, dry cloth
and the inside with a lukewarm wet cloth.
Place the appliance on a oor that is strong enough to support it when it is fully loaded.
Do not place the appliance in direct sunlight or near sources of heat, such as a stove or heater, as this can increase
electrical consumption. Extreme cold ambient temperatures may also cause the appliance to perform improperly.
Do not use the appliance near water, for example in a wet basement or near a sink.
This appliance is intended for household use only. It is not designed for outside installation, including anywhere that
is not temperature controlled (garages, porches, vehicles, etc.).
Before connecting the appliance to a power source, let it stand upright for approximately six hours. This will reduce
the possibility of a malfunction in the cooling system from handling during transportation.
This appliance is 60.5 cm (23.8 inches) wide by 87.5 cm (34.5 inches) high by 64.5 cm (25.4 inches) deep including
the handle. Do not cover any of the ventilation openings with any material as the appliance needs adequate space
to breathe.
Allow 12.7 cm (5 inches) of space between the back, sides and top of the appliance and all adjacent walls.
This appliance is intended for free-standing installation only and is not intended to be built into a cabinet or counter.
Building in this appliance can cause it to malfunction.
The door handle is shipped inside the cabinet to avoid damage during shipping. It can be installed using the provided
hex key and hexagon bolts found in the accessory bag.
CAUTION:
the appliance is in operation. Failure to fully close
the door can lead to excessive condensation and
potential water damage to oor under the
appliance. Vissani will not be responsible for
damages from misuse.

TOOLS REQUIRED

Tape measure
placed on its
If the appliance is
4

Advertisement

Table of Contents
loading

This manual is also suitable for:

1009025763

Table of Contents