ZPE Nodegrid Hive SR Quick Start Manual

Security Warning

The Nodegrid Hive SR (HSR)
provides access to the
internet for devices attached
to the LAN ports. As a result,
care must be taken to avoid
compromising your security
policies.
From the factory, this
equipment is shipped with
the following settings:
• DHCP – ENABLED in WAN
and SFP ports
• DHCP Server – ENABLED in
LAN ports
• USB, SFP, WAN, and LAN
ports – ENABLED
• Firewall – ENABLED in
WAN and SFP ports
• One default user with
passwords:
– admin / admin
ZPE requires changing the
default passwords of admin
at the first login, as well as
carefully configuring security
settings immediately after
initial setup.
Please consult the HSR User
Guide for more information
on security settings.
Please consult the HSR Safety
Information before
installation.
This equipment is intended
only for installation in a
RESTRICTED ACCESS
LOCATION.
By installing, copying, or otherwise using this device, you agree to be bound by the terms of the licensing, maintenance and sale agreements set forth on
www.zpesystems.com/docs/legal. if you do not agree to the terms of those agreements, do not install or use the Hardware and/or Software Product(s).
Quick Start Guide for Nodegrid Hive SR
1
Rack mounting, wall
mounting, or desktop
(desktop shown)
Back
Console
3
Side
1
Desktop, wall mount, or rack mount
your HSR
For detailed rack mounting and wall
mounting instructions, see the Nodegrid
Manual.
2

Connect to your network

Connect a ZPE-recommended
CAT 5e or CAT 6 cable from the
WAN0 port to your network.
Note: All remaining manual setup steps are required the first time you configure your HSR.
For manual downloads and support, visit:
For further assistance please contact ZPE Technical Support (support@zpesystems.com).
Nodegrid Hive SR
WAN0
2
3

Connect to the Serial Console port

Using the ZPE's RJ-45 console adaptor,
connect a terminal or workstation to the
serial console port on the HSR. The HSR will
be configured using a terminal or terminal
emulator with session settings of: 115200
bps, 8, N, 1 no flow control.
4

Connect power adaptor to turn HSR on

Connect the power cord to the appliance.
Power will automatically turn on.
docs.zpesystems.com
Nodegrid Hive SR
4G/LTE
Wi-Fi
Optional
Optional
Antenna
Antenna
DC power adaptor
4
Optional
SIM card
TM