WAC 1D2T MICRO is a new outstanding T & A standalone controller with an OLED screen developed by WATCHNET. The WAC 1D2T MICRO can work together with a fingerprint reader as T&A controller. The employees will need to present their fingers on the Fingerprint Reader to complete attendance. The OLED screen will display time and staff ID information.
T&A. Its 3 flexible uses are as below. T&A:The WAC 1D2T MICRO can directly communicate with host PC via RS485 or TCP/IP managed by the WatchNET Access Software. Single Door Controller:The WAC 1D2T MICRO can work as an access controller with external readers for single door In/Out control.
Page 7
TCP/IP interface, as shown below: Figure 2-3 Icon Connection Definition Icon Connection Definition Power supply Magnetic, Rex BELL Button, Door bell Auxiliary BELL output 485- 485 interface 485+ TCP/IP interface Reader signal output External reader COM1 interface Relay output COM2 Page 7 of 21 351 Ferrier Street •...
Wiring Description: J1: Power Supply 12V:DC 12V Positive GND:Ground J2: Door Bell Normally, J2 outputs open signal if is not pressed. If door bell is used, is pressed and J2 will outputs close signal to drive door bell rings. J3: 485 Interfaces ...
2.4 RS485 Net Bus The WAC 1D2T MICRO can communicate via half-duplex RS485 bus and up to a 1200m communication distance. Terminals use series connection. Please make sure power supply is in off state before wiring. This helps to avoid any damage that might be caused to the device.
Page 11
TCP/IP Connector RJ45 NO. Connection Figure 2-9 Sheet 2-2 Normal net cable(to switch) ← ← 图2-10 Crossed cable(to PC) ← ← Figure 2-11 Page 11 of 21 351 Ferrier Street • Markham, ON • L3R 5Z2 PHONE: 416-410-6865 TOLL FREE: 1-866-331-3341 • FAX: 905-752-0186 www.watchnetaccess.com / info@watchnetinc.com...
Chapter3 Instructions User Management, PIN management, Work mode and Time set are configured in the manage menu. Menu structure is shown below. Press * 39 # to enter manage menu when idle. In the main menu, “*” works as “cancel”, “#” works as “confirm”, “3”...