Table of Contents
Advertisement
ENGLISH
NT5650, 5600, 3650
1
11
12
13
1
2
NT5650
NT5600
10
14
3
4
8
9
7
6
5
2
3
4
5
6
7
9
10
8
11
12
13
14
15
16
17
18
19
2 min.
Max.
20
21
Warning
-
This appliance can be used by children aged
from 8 years and above and persons with
reduced physical, sensory or mental capabilities
or lack of experience and knowledge if they
have been given supervision or instruction
concerning use of the appliance in a safe way
and understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.
-
Always check the appliance before you use
it. Do not use the appliance if it is damaged,
as this may cause injury. Always replace a
damaged part with one of the original type.
Caution
-
Never immerse the appliance in water. Do not
use the appliance in the bath or shower.
-
Never use water hotter than 60 °C to rinse the
appliance.
-
Only use this appliance for its intended purpose
as shown in the user manual.
-
Use and store the appliance at a temperature
between 15 °C and 35 °C.
-
For hygienic reasons, the appliance should only
be used by one person.
-
Do not expose the appliance to direct sunlight.
-
Only operate the appliance on 1.5V AA alkaline
batteries.
-
Do not recharge non-rechargeable batteries.
-
Insert batteries with the + and - poles pointing
in the direction indicated in the battery
compartment or holder.
-
Do not short-circuit the supply terminals of
batteries.
-
Remove batteries from the appliance if you are
not going to use it for some time.
-
Never use compressed air, scouring pads,
abrasive cleaning agents or aggressive
liquids such as petrol or acetone to clean the
appliance.
Electromagnetic fields (EMF)
This Philips appliance complies with all applicable
standards and regulations regarding exposure to
electromagnetic fields.
General
-
This appliance can be safely cleaned under the
tap.
Introduction
Congratulations on your purchase and welcome
to Philips! To fully benefit from the support that
Philips offers, register your product at www.philips.
com/welcome.
General description (Fig. 1)
1 Short eyebrow comb (1/8 in, 3 mm)
2 Long eyebrow comb (13/64 in, 5 mm)
3 Cutting element
4 Trimming head
5 ‚Unlocked' indication
6 ‚Locked' indication
7 Setting indicator
8 Handle
9 On/off slide
10 Detailer (NT5600 & NT5650 only)
11 Comb for detailer (NT5600 & NT5650 only)
12 AA battery
13 Cleaning brush
14 Pouch
Preparing for use
Inserting the battery
Note: Make sure your hands and appliance are dry
when you insert the battery.
1 To remove the battery compartment cover,
turn it until the setting indicator points to the
‚unlocked' indication (^).
2 Pull the battery compartment cover off the
handle (Fig. 3).
3 Put the battery in the battery compartment
(Fig. 4).
Make sure the + and - poles of the battery
point in the right direction.
Note: The appliance operates on one
replaceable AA 1.5-volt battery (included).
4 Slide the battery compartment cover back onto
the handle (Fig. 5).
5 Turn the battery compartment cover until
the setting indicator points to the ‚locked'
indication (0) (Fig. 6).
Using the appliance
Switching the appliance on and off
1 To switch on the appliance, slide the on/off
slide upwards.
2 To switch off the appliance, slide the on/off
slide downwards.
Detaching and attaching the attachments
Note: Switch off the appliance before detaching or
attaching the attachments.
1 To detach the trimming head from the handle,
firmly grasp the attachment below the cutting
element and turn it until the setting indicator
points to the ‚unlocked' indication (^).
2 Lift the trimming head off of the handle.
1 To attach the trimming head to the handle,
place the attachment on the handle with the
setting indicator pointing to the ‚unlocked'
indication (^).
2 Firmly grap the attachment below the cutting
element and turn it until the setting indicator
points to the ‚locked' indication (0).
Tip: If the trimming head becomes clogged, detach
the attachment and rinse it thoroughly with warm
water before you reattach it.
Trimming eyebrows with the eyebrow
combs
1 Comb your eyebrows in the direction of hair
growth (Fig. 7).
2 Make sure the appliance is switched off. Slide
the eyebrow comb onto the trimming head
(Fig. 8). The short eyebrow comb trims the hairs
to a length of 3 mm (1/8 in). The long eyebrow
comb trims the hairs to a length of 5 mm
(13/64 in).
Note: Make sure the comb slides into the
grooves on both sides of the trimmer.
3 Switch on the appliance.
4 Move the comb over the eyebrow from the
outer tip of the eyebrow towards the base of
the nose (against the direction of hair growth)
(Fig. 9).
5 Clean thoroughly after each use (see ‚Cleaning').
Trimming ear hair
Make sure your outer ear channels are clean and
free from wax.
1 Switch on the appliance.
2 Slowly move the trimming head along the rim of
the ear to remove hairs that stick out beyond
the rim.
Do not insert the trimming head more than 5 mm
(13/64 in) into your ear channel, as this could
damage the eardrum.
1 Carefully insert the trimming head into the outer
ear channel.
2 Slowly turn the trimming head around to
remove all unwanted hairs from your outer ear
channel (Fig. 10).
3 Clean thoroughly after each use (see ‚Cleaning').
Trimming nose hair
Make sure both the appliance and nasal passages
are clean before trimming. Dried nasal mucus
can block the cutting element, preventing the
appliance from turning on.
1 Switch on the appliance.
2 Slowly move the trimming head along the rim
of the nostril to remove hairs that stick out
beyond the rim.
3 Carefully insert the trimming head into one of
your nostrils.
Do not insert the trimming head more than
5 mm (13/64 in) into your nostrils.
4 Slowly move the trimming head around inside
each nostril (Fig. 11), making sure the flat side
of the trimmer is held firmly against the skin.
(Fig. 12) This will reduce the tickling effect that
can occur.
5 Clean thoroughly after each use (see ‚Cleaning').
Using the detailer (NT5600 & NT5650
only)
Use the detailer to shape and maintain your beard,
sideburns and neck hair.
1 Attach the detailer to the handle. If applicable,
attach the 3 mm (1/8 in) comb to the detailer.
(Fig. 13)
2 Switch on the appliance.
3 Hold the appliance at a 45 degree angle to your
skin and apply gentle pressure. (Fig. 14)
4 Use slow upward and downward strokes
to remove unwanted hairs. To trim most
effectively, move the appliance against the
direction of hair growth.
Tip: Make smooth and gentle movements and
make sure the surface of the detailer always stays
in contact with the skin.
Cleaning
Cleaning the trimming head
Do not immerse the motor unit in water or any
other liquid.
Never use scouring pads, abrasive cleaning agents
or aggressive liquids such as gasoline or acetone
to clean the appliance or any attachments or
accessories.
Do not tap on the cutting elements.
Do not use any sharp objects to clean the cutting
elements.
Clean the trimming head immediately after use
and when a lot of hair or dirt has accumulated on
the cutting elements.
1 Use the cleaning brush to remove any excess
hair from the cutting element. (Fig. 15)
2 Rinse the cutting element of the trimming head
with hot water (Fig. 16).
3 Switch on the appliance and rinse the cutting
element and trimming head again (Fig. 16) to
remove any remaining hairs. Then switch off
the appliance again.
Tip: If rinsing the trimming head under the tap
is not sufficient, immerse the trimming head in
a glass with warm water for a few minutes (Fig.
17). Then switch on the appliance and rinse it
under the tap.
4 Rinse the combs with lukewarm water (Fig. 18).
You can also use the cleaning brush to clean the
eyebrow combs.
5 Carefully shake off excess water and let all parts
air dry (Fig. 21).
Cleaning the detailer (NT5600 & NT5650
only)
Clean the detailer and comb immediately after use
and when a lot of hair or dirt has accumulated on
the cutting elements.
1 Use the brush to remove any excess hair from
the detailer (Fig. 19) and comb.
2 Switch on the appliance and rinse the detailer
under the tap with water water (Fig. 20).
3 Turn off the appliance again.
4 Rinse the detailer comb under the tap with
warm water.
5 Carefully shake off excess water and let all parts
air dry (Fig. 21).
Let all parts dry completely before you use the
appliance again.
Storage
Store the appliance in a safe, dry location, using
the pouch provided. Ensure that the appliance and
accessories are completely dry before inserting
them into the pouch.
Recycling
-
Do not throw away the product with the
normal household waste at the end of its life,
but hand it in at an official collection point for
recycling. By doing this, you help to preserve
the environment.
-
This product contains disposable batteries
which shall not be disposed of with normal
household waste.
-
Follow your country's rules for the separate
collection of electrical and electronic products
and batteries. Correct disposal helps prevent
negative consequences for the environment
and human health.
Removing the disposable batteries
To remove the disposable batteries, see chapter
‚Preparing for use'.
Warranty and support
If you need information or support, please
visit www.philips.com/support or read the
international warranty leaflet.
Warranty restrictions
Cutting units are not covered by the terms of the
international warranty because they are subject to
wear.
Advertisement
Table of Contents
