Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Smartgen HWP60A
Summary of Contents for Smartgen HWP60A
- Page 1 HWP60A/HWP90A FORCED CIRCULATION HEATER USER MANUAL...
- Page 2 SmartGen Technology at the address above. Any reference to trademarked product names used within this publication is owned by their respective companies. SmartGen Technology reserves the right to change the contents of this document without prior notice. Table 1 Software Version Date...
-
Page 3: Table Of Contents
5.4 OPERATION DESCRIPTION ......................8 6. USE AND MAINTENANCE ........................9 6.1 VENT VALVE ............................9 6.2 WATER DRAIN VALVE ........................9 7. CONNECTIONS ............................11 8. CASE AND DIMENSIONS ........................12 HWP60A/HWP90A Forced Circulation Heater User Manual Page 3 of 12... -
Page 4: Overview
OVERVIEW HWP60A/HWP90A forced circulation engine water heater is composed of 3 parts (control section, water pump and water heater). If the outside temperature is lower than 4ºC, engine coolant and lubricant may condense into solid state and lose their lubricating and cooling properties during cranking, which can damage the engine. -
Page 5: Specification
Protection Level IP44 (5~8)Hz Amplitude±7.5mm Triaxial Vibration Resistance (8~500)Hz a=2g Triaxial Shock Resistance Half-sine Wave; a =50g; Triaxial peak Working Temperature -40ºC~+70ºC Storage Temperature -40ºC~+80ºC Case Dimensions 504mm×255mm×426mm Weight 15kg HWP60A/HWP90A Forced Circulation Heater User Manual Page 5 of 12... -
Page 6: Installation Instruction
Fig.1 Working Diagram Fig.2 Installation Diagram HWP60A/HWP90A Forced Circulation Heater User Manual Page 6 of 12... -
Page 7: Operating Instructions
The heater is heating on when the “Heating” indicator is illuminated while the Thermostat is open and the heater stops heating when the “Overheat” indicator is flashing. Temp. Display: OFF Temp. Display: ON Temp. Display: Current Temp. Alarm: Sensor Abnormal HWP60A/HWP90A Forced Circulation Heater User Manual Page 7 of 12... -
Page 8: Panel Description
After doing these, press button, the LED will back the current temperature. All the adjustment should be saved and not lost even when power is off. HWP60A/HWP90A Forced Circulation Heater User Manual Page 8 of 12... -
Page 9: Use And Maintenance
HWP60A/HWP90A Forced Circulation Heater User Manual Page 9 of 12... - Page 10 The cable of the power supply is too long and result in dividing resistance of the cable. Solutions: 1. Replace the heater whose power matches the engine; 2. Shorten the power cable as possible and increase the cable diameter. HWP60A/HWP90A Forced Circulation Heater User Manual Page 10 of 12...
-
Page 11: Connections
CONNECTIONS Fig.7 Schematic Diagram Use 4mm power cable for tie-in. Earth line must be soundly connected to earth. HWP60A/HWP90A Forced Circulation Heater User Manual Page 11 of 12... -
Page 12: Case And Dimensions
CASE AND DIMENSIONS unit: mm Fig.8 Overall Dimensions NOTE: All the inlets/outlets connectors are Pagoda-shape. _________________________________ HWP60A/HWP90A Forced Circulation Heater User Manual Page 12 of 12...