JNS Aquaria FR-S Quick Start Manual

FR-S / FR-M

Internal GFO Carbon and Biopellet Filter

Media Reactor

www.jnsaquaria.com
info@jnsaquaria.com
Please open the package carefully, and check if
1 there's any damaged or missing part.
FR-S
(1) Main media reactor body and lid
(2) Pump: Sicce Syncra Nano
(3) Sponges *4
FR-M
(1) Main media reactor body and lid
(2) Pump: Sicce Micra
(3) Sponges *4
You can change the order of the sponges depends
on media size. Original setting (top-bottom):
coarse - fine - fine - coarse
While we take great care to keep any contaminants
2
away from our products during assembly, please
take a moment to clean with warm water ONLY.
Never clean Acrylic with alcohol-based products. Use
caution when handling acrylic scratches easily.
Some media (such as phosphate control products) is
3 not designed to be aggressively fluidized in a reactor
‒ please read the instructions for your media
carefully.
Wash your media before you use it. It is recommended
4
that biopellets are soaked for 24 hours in aquarium
water before use. Start with 25% of the total amount
of biopellets then add 25% more weekly.
Biopellets may initially clump during break-in. Turn off
5 the pump and allow the clumps to settle at the bottom
of the reactor. Gently shake the reactor to break up
clumps. Once the pellets go through this initial
break-in process, they generally require no further
action.
For media designed to be fully fluidized, the
6 reactor should be filled no more than 2/3 full to
allow the media room to move around. With heavy
or fine media, you may need to add less.
To fill in the media:
7
(1) Turn counterclockwise to release the lid
(2) Pick up the upper sponges to fill in the media.
Sponges are not
necessary for Biopellet,
if you are going to use
Biopellet, you can pick
up all the sponges.
(3) Put back the sponges.
(could be skipped for Biopellet)
(4) Turn clockwise to tighten the lid.
Do not over-tighten.