ZINK ZN-35688 Quick Start Manual

Lynn 2 x 10W LED
With PIR Sensor
INS ZN 35688 - D
Instruction
The product is an energy-saving automatic sensor lamp.
It can identify day and night. The lamp can be activated when someone enters the detection eld
and can turn o automatically when they leave the detection eld.

SPECIFICATION:

Power Source: 220-240V/AC
Power Frequency: 50/60Hz
Ambient Light: <3-2000LUX (adjustable)
Time Delay: Min.10sec±3sec
Max.5min±1min
Rated Load: 20W (1500LM)
Detection Range: 180°
Detection Distance: 5-12m(<24! )Adjustable
Working Temperature: -20~+40!
Working Humidity: <93%RH
Installation Height: 1.8-2.5m
Detection Moving Speed: 0.6-1.5m/s

FUNCTION:

The sensor can identify day and night: You can adjust working states in di erent ambient light.
It can operate during the daytime and at night when it is adjusted on the "sun" position (max).
It can operate in ambient light less than 3LUX when it is adjusted on the "moon" position (min).
As for making adjustments, please refer to the testing and troubleshooting sections of this manual.
SENS adjustable: It can be adjusted according to using location. The detection distance of low
sensitivity could be only 5m and high sensitivity could be 12m which ts for large room.
Time - When the unit receives another induction signal during its rst activation, it will restart
the timer from that moment, delaying the time it will shut down. This is added continually:
Adjustable Time Delay: the length of time delay could be set according to the customers'
requirement, the minimum time of this item is 10sec ± 3sec, the maximum is 5min±1min.
Good sensitivity

INSTALLATION:

Switch o the power.
Detatch the front of the tting by removing
the two locking screws. Open the wire
hole in the backplate and pass the mains wire
through the hole. (Ensure that the rubber seal
is tight around the wire.)
Secure the Backplate to the mounting surface using the screws provided.
Connect the mains wire into the terminal block according to the connection-wire diagram.
Re-attach the cover onto the backplate, taking care
not to trap any loose wiring.
Switch on the power and then you can test the tting.
The sensor head and two LED can tilt up/down,
turn left/right according to the customers'
requirement as the drawing shown right:
.
Poor sensitivity