Returning For Servicing - R&S RT-Z1M Manual

®
R&S RT‑Z1M

5.3 Returning for servicing

Use the original packaging to return your R&S RT‑Z1M to your Rohde & Schwarzser-
vice center. A list of all service centers is available on:
www.services.rohde-schwarz.com
If you cannot use the original packaging, consider the following:
1. Use a sufficiently sized box.
2. Protect the product from damage and moisture (e.g. with bubble wrap).
3. Use some kind of protective material (e.g. crumpled newspaper) to stabilize the
product inside the box.
4. Seal the box with tape.
5. Address the package to your nearest Rohde & Schwarz service center.
5.4 Calibration interval
The recommended calibration interval for R&S RT‑Z1M high-impedance buffer ampli-
fier is two years. For servicing, send the probe to your nearest Rohde & Schwarz ser-
vice center (see
5.5 Storage and transport
Protect the product against dust. Ensure that the environmental conditions, e.g. tem-
perature range and climatic load, meet the values specified in the data sheet.
Store the product in a shock-resistant case, e.g. in the shipping case.
Unless otherwise specified in the data sheet, the maximum transport altitude without
pressure compensation is 4500 m above sea level.
5.6 Disposal
Rohde & Schwarz is committed to making careful, ecologically sound use of natural
resources and minimizing the environmental footprint of our products. Help us by dis-
posing of waste in a way that causes minimum environmental impact.
Disposing of electrical and electronic equipment
A product that is labeled as follows cannot be disposed of in normal household waste
after it has come to the end of its life. Even disposal via the municipal collection points
for waste electrical and electronic equipment is not permitted.
Manual 1801.3142.02 ─ 05
Chapter 5.3, "Returning for
Maintenance and service
servicing", on page 18).
Disposal
18