Advertisement
WARNING
NON-COMPLIANCE WITH REQUIREMENTS UNDER THIS HEADING COULD CREATE
CIRCUMSTANCES WHICH MAY LEAD TO PERSONAL INJURY AND/OR WHICH MAY CAUSE
DAMAGE TO THE PUMPSET AND OR ANCILLARY EQUIPMENT
CAUTION
ITEMS UNDER THIS HEADING DRAW ATTENTION TO LEGAL AND/OR STATUTORY
REQUIREMENTS WHICH CONTROL THE INSTALLATION AND USE OF THIS TYPE OF
EQUIPMENT.
DANGEROUS SITUATION AND/OR RESULT IN DAMAGE TO THE PUMPSET AND
ANCILLARY EQUIPMENT.
NOTE
Items under this heading are to draw attention to assembly procedures, techniques and
methods of operation etc. which are important to ensure correct installation and operation
of equipment and which, if not followed, may result in damage, failure or poor performance
of pumpset and ancillary equipment.
Error! Bookmark not defined.
1.1 -
CAUTION
INSTALLATION AND SERVICING OF THESE
VALVES
SHOULD
BE
QUALIFIED,
COMPETENT
ACCORDANCE WITH RELEVANT STATUTORY
REGULATIONS OR CODES, IN CONJUNCTION
WITH THESE INSTRUCTIONS.
1.2 -
WARNING
THESE VALVES MUST BE OPERATED WITHIN
THE
ORIGINAL
PARAMETERS OF PRESSURE, TEMPERATURE,
FLOW AND VISCOSITY. SHOULD ANY CHANGE
BE CONTEMPLATED, PLEASE CONFER WITH
EBSRAY IN ORDER TO VERIFY THE SUITABILITY
OF SUCH A CHANGE.
1.3 TRANSPORTATION AND PACKING
Standard domestic packing is suitable for shipment in
covered transports. Ports must be sealed to exclude
ingress of solids. When received on site the valve
should be stored in a dry covered area.
Ensure pipework is clean before installation. Bypass
Valve must only be installed in accurately aligned
pipework to ensure that pipe stresses are not
transferred to valve housing. The port which is
opposite the Adjusting Screw is the inlet port and the
other port is the outlet port.
The preferred installation orientation is with the
adjusting screw up however the valve may be
mounted in any position as required by the
installation and available space. Ensure that the
adjusting screw is accessible
SECTION 1- GENERAL
NON-COMPLIANCE
CARRIED
OUT
BY
PERSONNEL
IN
SELECTED
DESIGN
SECTION 2- INSTALLATION
WITH
THESE
REQUIREMENTS
1.4 INSPECTION ON RECEIPT
On receipt of equipment, check all items against the
dispatch documents and inspect for damage. Any
damage or shortage incurred during transit should be
noted on the packing note and on both your own and
the carrier's copy of the consignment note and a
claim should be made immediately on the transport
company. Should a shortage be evident on receipt,
notify EBSRAY immediately giving full details and
packing note number.
1.5 STORAGE
If storage is required for other than a short period
prior to installation, special preservatives and
protective wrappings will be required.
2
MAY
CREATE
WARNING
NEVER ALLOW WATER OR
ANY CORROSIVE PRODUCT TO
ENTER THE VALVE AS THIS
MAY DAMAGE THE VALVE AND
WILL VOID THE WARRANTY.
A
Advertisement
