Safety Precautions - Fujitsu ASTG34KMTA Operating Manual

Safety Precautions (continued)
• This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not
play with the appliance.
• Do not install the unit in area filled with mineral oil such as a
factory or area containing a large amount of splashed oil or
steam such as a kitchen.
• Do not start or stop the operation of this product by turning
on or off the circuit breaker.
• Provide occasional ventilation during use.
• Always operate the unit with air filters installed.
• Ensure that any electronic equipment is at least 1 meter
away from either the indoor unit or outdoor unit.
• Turn off power source when not using this product for
extended periods.
• After long period of use, check whether the installation stand
does not deteriorate to prevent the unit from falling down.
• The airflow direction and the room temperature should be
carefully considered when you use this product in a room
with infants, children, elderly or sick persons.
• Do not direct the airflow at fireplaces or heating apparatus.
• Do not block or cover the intake grille and the outlet port.
• Do not apply any heavy pressure to radiator fins.
• Do not climb on, place objects on, or hang objects from this
product.
Indoor unit accessories
Remote Remote controller
controller holder
Air cleaning filters
Batteries
1
5 Press "CLOCK ADJUST" button to start clock setting.
6 Set the day of the week by pressing "SELECT" button (Monday
to Sunday). *By pressing the "TEMP.
indicator can be changed from a 24-hour to a 12-hour clock.
Press "NEXT" button to continue.
7
8 Set the time by pressing "SELECT" button.
Pressing  or  changes the value by the minute.
Pressing down on  or  changes the value by 10 minutes.
En-2 OPERATING MANUAL
Tapping screws
Filter holders
Battery (R03/LR03/AAA × 2) loading and remote controller preparation
3
2
" buttons, the time
( / )
WARNING
• Do not use inflammable gases near this product.
• Do not expose yourself directly to the cooling airflow for
many hours.
• Do not insert your fingers or any other objects into outlet port
or inlet port.
• Do not operate with wet hands.
• Do not use means to accelerate the defrosting process or to
clean the appliance, other than those recommended by the
manufacturer.
• Do not pierce or burn.
CAUTION
• Do not place any other electrical products or household
belongings under this product.
Dripping condensation from this product might get them wet,
and may cause damage or malfunction of your property.
• Do not expose this product directly to water.
• Do not use this product for preservation of food, plants,
animals, precision equipment, art work, or other objects. This
may cause quality deterioration of those items.
• Do not expose animals or plants to the direct airflow.
• Do not drink the drainage from the air conditioner.
• Do not pull the power supply cable.
• Do not touch the aluminum fins of heat exchanger built-in this
product to avoid personal injury when you install or maintain
the unit.
Remote controller holder installation
1
Screws
Take care to prevent infants and young children from acciden-
tally swallowing the batteries.
• Do not attempt to recharge dry batteries.
• Do not use dry batteries that has been recharged.
4
9
5
9 To complete, press the "SEND" button close to the indoor unit.
Settings may not be properly sent if pressed from a distance.
Notes:
• Use specified type of batteries only.
• Do not mix different types or new and used batteries together.
• Batteries can be used about 1 year in ordinary use.
• If the remote control range noticeably shortens, replace the batter-
ies, and press "RESET" button as shown in page 5.
2 3
Slide up
Insert
WARNING
CAUTION
7
6
8