Ordering Accessories; Warranty And Support; Troubleshooting - Philips HD6592 Manual

Hide thumbs Also See for HD6592:
Table of Contents

Advertisement

Available languages

Available languages

English
14
13 When the 1-cup button and the CALC light start to flash quickly alternately (Fig. 31), remove the
used pod from the 2-cup pod holder. Clean the water reservoir by rinsing it thoroughly with cold
clean tap water a few times (Fig. 48).
14 Fill the water reservoir with clean cold water up to the MAX indication and put it back onto the
machine.
15 Press the 1-cup button. The CALC light, jug button, 2-cup button and 1-cup button flash slowly in
sequence (Fig. 46). During the flushing cycle, the water comes out of the machine at intervals.
16 When all the water in the water reservoir has been used up, the 1-cup button and CALC light start
to flash quickly alternately (Fig. 31).
17 Repeat steps 13 and 14.
-
When all the water in the water reservoir has been used up, the machine switches off and all the
lights go out to indicate that the descaling procedure has ended.

Ordering accessories

To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer.
You can also contact the Philips Consumer Care Center in your country (see the international warranty
leaflet for contact details).

Warranty and support

If you need information or support, please visit www.philips.com/support or read the international
warranty leaflet.
Recycling
- This symbol means that this product shall not be disposed of with normal household waste
(2012/19/EU) (Fig. 49).
- Follow your country's rules for the separate collection of electrical and electronic products. Correct
disposal helps prevent negative consequences for the environment and human health.

Troubleshooting

This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Problem
My coffee cup overflows
with cold coffee
The light in the button you
pressed flashes slowly.
Possible cause
You did not flush the machine
before first use.
The machine is heating up.
When you are brewing drip
filter coffee, the light flashes
slowly during brewing.
Solution
Flush the machine before first
use.When the machine has emptied a
complete water reservoir, you can start
to make a new coffee.
If heating up takes longer than two
minutes, contact the Philips Consumer
Care Center in your country.
The brewing cycle last approximately
90 seconds, wait until the brewing
cycle has finished.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hd6596Hd6592/04

Table of Contents