Important Safety Instructions; Appliance Handling Safety; Safety Codes And Standards; Electric Safety - Bosch 500 Series Installation Manual

IMPORTANT SAFETY INSTRUCTIONS

9
READ AND SAVE THESE INSTRUCTIONS
I M P O R T A N T S A F E T Y I N S T R U C T I O N S R E A D A N D S A V E T H E S E I N S T R U C T I O N S
WARNING
When properly cared for, your new appliance has been
designed to be safe and reliable. Read all instructions
carefully before use. These precautions will reduce the
risk of burns, electric shock, fire, and injury to persons.
When using kitchen appliances, basic safety precautions
must be followed, including those in the following pages.
WARNING
If the information in this manual is not followed exactly,
fire or shock may result causing property damage or
personal injury.
WARNING
Do not repair, replace or remove any part of the
appliance unless specifically recommended in the
manuals. Improper installation, service or maintenance
can cause injury or property damage. Refer to this
manual for guidance. All other servicing should be done
by an authorized service provider.
This appliance is intended for use at an elevation of no
more than 2000 meters above sea level.

Appliance Handling Safety

Unit is heavy and requires at least two people or proper
equipment to move.
Do not lift appliance by door handle.
Hidden surfaces may have sharp edges.
Use caution when reaching behind or
under appliance.

Safety Codes and Standards

This appliance complies with the latest version of one or
more of the following standards:
CAN/CSA C22.2 No. 61 - Household Cooking Ranges
▯
UL 858 - Household Electric Ranges
▯
CAN/CSA C22.2 No. 150 - Microwave Ovens
▯
UL 923 - Microwave Cooking Appliances
▯
CSA C22.2 No. 64 - Household Cooking and Liquid-
▯
Heating Appliances
UL 1026 - Electric Household Cooking and Food
▯
Serving Appliances
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.

Electric Safety

WARNING
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
Installer – show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
INSTALLER: LEAVE THESE INSTRUCTIONS WITH THE
APPLIANCE AFTER INSTALLATION IS COMPLETE.
IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE
LOCAL ELECTRICAL INSPECTOR'S USE.
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Refer to data plate for more information. See "Data
Plate" under "Service" for data plate location.
Be sure your appliance is properly installed and
grounded by a qualified technician. Installation, electrical
connections and grounding must comply with all
applicable codes.

Related Equipment Safety

Remove all tape and packaging before using the
appliance. Destroy the packaging after unpacking the
appliance. Never allow children to play with packaging
material
Never modify or alter the construction of the appliance.
For example, do not remove leveling legs, panels, wire
covers or anti-tip brackets/screws.
Before starting up the appliance, remove any packaging
material and adhesive film from the cooking
compartment and the door.

Proposition 65 Warning:

This product may contain a chemical known to the State
of California, which can cause cancer or reproductive
harm. Therefore, the packaging of your product may
bear the following label as required by California:
3