Voltage Selection; Parameter Configuration - Ebyte E15-USB-T2-V2.0 User Manual

Chengdu Ebyte Electronic Technology Co.,Ltd.

4. Voltage Selection

5. Parameter Configuration

Steps Operation
Install the
1
driver
Unplug the
2
jumper
Connect the
3
module
Open the
4
serial port
Enter the
5
interface
6
parameters
Complete
7
operation
Command
8 configuratio
Copyright ©2012–2022 Chengdu Ebyte Electronic Technology Co.,Ltd.
Please install the USB adapter driver (CH340X) in the package first.
Unplug the jumper caps at M0 and M1 on the USB adapter board as
shown below; choose either 3.3V or 5V for the power jumper caps.
Insert the module into the 7PIN holder of the adapter board with the
antenna end outward; then plug the adapter board into the USB port of
Open our parameter configuration software, select the corresponding
Click "Read module parameters", the interface is shown below.
Write If the reading fails, please check whether the module is in mode 3, or
If you need to change the corresponding configuration, please adjust the
the parameters to be modified; click "Write" button to write the new
If you need to reconfigure the module, please click "Step 5"; if the
configuration is finished, please click "Close Serial Port" and then
n
Detailed description
the computer.
serial port number and click "Open serial port".
whether the adapter driver has been installed.
parameters to the module.
remove the module.
E15-USB-T2-V2.0 Datasheet
6