Troubleshooting - Intex 126384GS Owner's Manual

POOL ENCLOSURE SETUP (continued)
5. Top Board Installation
Attach the top board (12) on the top of the side panel, with the holes at its two ends aligning with the nuts
on the top clamps (13). Make sure the groove underneath the top board fits firmly onto the tongue of the
top board (12). Repeat this procedure until all the top boards are fixed to the top clamps and side boards.
NOTE: There are four pieces of top board which are printed with warnings. Install those four top boards
three pieces apart from each other (see drawings 13.1 - 13.3).
6. Top Clamp Cover Installation
Install the top clamp cover (11) where the two top boards meet. Insert the ridge of top clamp cover into
the slot on the top end of the support post. Align the top holes on top clamp cover with the nuts of the top
clamp. Insert and screw bolt (10) to each of the threaded holes by using the wrench (22) provided, and
then cover with the waterproof caps (9). Repeat this procedure until all the top clamp covers are fixed to
the top clamps and support posts (see drawings 14.1 - 14.3).
PROBLEM
ALGAE • Greenish water.
• Green or black spots on pool
liner.
• Pool liner is slippery and/or has
a bad odor.
COLORED WATER • Water turns blue, brown, or
black when first treated with
chlorine.
FLOATING MATTER IN • Water is cloudy or milky.
WATER
CHRONIC LOW WATER • Level is lower than on previous
day.
LEVEL
SEDIMENT ON POOL
• Dirt or sand on pool floor.
BOTTOM
SURFACE DEBRIS • Leaves, insects etc.
SAVE THESE INSTRUCTIONS
(120IO) GRAPHITE GRAY PANEL™ POOL ENGLISH 7.5" X 10.3" PANTONE 295U 04/20/2022
13.1
14.1

TROUBLESHOOTING

DESCRIPTION
• Chlorine and pH level need
adjustment.
• Copper, iron or manganese in
water being oxidized by the
added chlorine.
• "Hard water" caused by a too
high pH level.
• Chlorine content is low.
• Foreign matter in water.
• Rip or hole in pool liner or
hoses.
• Heavy use, getting in and out
of pool.
• Pool too close to trees.
13.2
14.2
NOTE: Drawings for illustration
purpose only.
CAUSE
• Super chlorinate with shock treatment.
Correct pH to your pool store's
recommended level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH to recommended level.
• Run filter until water is clear.
• Replace cartridge frequently.
• Correct the pH level. Check with your
pool dealer for advice.
• Check for proper chlorine level.
• Clean or replace your filter cartridge.
• Repair with patch kit.
• Finger tighten all caps.
• Replace the hoses.
• Use Intex pool vacuum to clean bottom
of pool.
• Use Intex pool skimmer.
120
English
A
13.3
14.3
SOLUTION
Page 15