Wireless Remote Controller - LG L3UC242FA2 Owner's Manual

Wireless Remote Controller

The controls will look like the following.
5
6
4
2
7
ON OFF
11
8
18
13
Operation Mode
Cooling Operation
Auto Operation
Healthy Dehumidification Operation
• Cooling Model( ), Heat Pump Model(
NOTE
To use the functions printed in blue at the bottom of the buttons press 2
button. Pressing the 2 nd F button activates the blue printed function of the respective button. To cancel the function
press the 2nd F button again else it will automatically cancel if remains idle after 10 seconds.
Signal transmitter
1
3
10
CANCEL
9
SET
12
AUTO CLEAN
16
15
17
14
Flip-up door
(opened)
)
1. START/STOP BUTTON
Used to turn off/on the unit.
2. OPERATION MODE SELECTION BUTTON
Used to select the operation mode.
3. ROOM TEMPERATURE SETTING BUTTONS
Used to select the room temperature.
4. INDOOR FAN SPEED SELECTOR BUTTON
Used to select fan speed in four steps
low, medium, high and CHAOS.
5. JET COOL BUTTON
Used to start or stop the speed cooling.
(It operates fan in super high speed in cooling mode)
6. CHAOS SWING BUTTON
Used to stop or start louver movement and set the
desired up/down airflow direction.
7. ON/OFF TIMER BUTTONS
Used to set the time of starting and stopping
operation.
8. TIME SETTING BUTTONS
Used to adjust the time.
9. TIMER SET/CANCEL BUTTON
Used to set and to cancel the timer operation.
10. SLEEP MODE AUTO BUTTON
Used to set sleep mode auto operation.
11. AIR CIRCULATION BUTTON
Used to circulate the room air without cooling
12. ROOM TEMPERATURE CHECKING BUTTON
Used to check the room temperature.
13. RESET BUTTON
Used prior to resetting time.
14. 2nd F BUTTON
Used prior to using modes printed in blue at the
bottom of buttons.
15. LCD LUMINOSITY(Optional)
Used to control the luminosity of the display on unit
16. AUTO CLEAN BUTTON
Used to set auto clean mode.
17. Horizontal Airflow Direction Control Button
(Optional)
Used to set the desired horizontal airflow direction.
18. PLASMA(OPTIONAL)
Used to start or stop the plasma-purification function.
nd F button first and then the required function
Operating Instructions
Owner's Manual 11