General Safety Regulations - GRE PP101 Instruction Manual

Hide thumbs Also See for PP101:

Instruction manual (56 pages)

Table of Contents

Available languages

(mm)

264

222

115

187

278

237

553

136

190

220

EN- Self-priming swimming pool pump

SAFETY INSTRUCTIONS. READ CAREFULLY

• All electrical installations should comply with the following standard;

NF C15-100

NF EN 60-335-2-41

that refers "to the construction of electrical installations, both in indoor and outdoor

swimming pools", or the equivalent standard in force in each region or country.

• All filtering should follow the C 15-100 installation standard that stipulates that all

electrical apparatus located at less than 3.5

m. from the pool and freely accessible, should be supplied by a very low voltage of 12

V. All apparatus supplied with 220 V should be located at least 3.5 m. from the swim-

ming pool edge. Ask the manufacturer for permission to make any modifications in

one or more elements of the filtering system.

• The electrical installation should be performed by professional staff qualified in elec-

trical installations.

• The apparatus must not be on while the pool is being used.

• Do not operate the apparatus unless it is properly primed.

• NEVER touch the apparatus when it is operating if you are wet or have wet hands.

• When handling the pump, DISCONNECT the power supply.

• Make sure that the ground is dry before touching the electrical equipment.

• Do not install the apparatus where it could become wet, as it may cause electrocu-

tion.

• Do not allow children or adults to lean against or sit on the apparatus.

• If the supply flex of the apparatus is damaged, it should be replaced. Read the ins-

tructions carefully to replace it. If in doubt, contact the technical service.

This mode allows making a correct installation with optimal results of your swim-

ming pool pump. Carefully read this instruction manual.

Your new pump is a one-stage self-priming, centrifugal pump, designed for use with

a swimming-pool filtering system. It is designed to be used with clean water for

temperatures between 5 ºC and 35 ºC. It is manufactured from high quality materials

subject to strict hydraulic and electrical tests. A correct installation of this pump is as-

sured by following the instructions from this manual. We decline all responsibility for

damages caused by use different to that explained in this instruction manual.

IMPORTANT

This manual contains basic information on the safety measures to be adopted during

installation and start- up. The fitter and the user must therefore read the instructions

before installation and start-up.