CEBEK FE-13 Quick Start Manual

The FE-13 module is 12 V. D.C. power supply perfectly stabilised with the possibility to short-circuit it and offering 5A. as maximum
output intensity.
Possibility to adjust the voltage between 10 and 15 V. D.C.
It include connection terminals to facilitate the assembly and operating indicator led.
Don't forget to read all the information mentioned hereafter to obtain a perfect operating of the module.
TRANSFORMER'S CONNECTION.
superior part with the indication 0, 125, 230 corresponding to the input voltage (coming form the mains) and 3 in the inferior part with
the indication 15, 0 and 15, corresponding to the output voltage, which must be connected to the module (PCB).
Connect cables of the mains input (230 V. A.C.) to the pins placed in the superior part of the transformer and indicated as 0 and 230
without taking account the central pin indicated as 125. See the transformer's wiring map hereafter.
Install a 1A. fuse and a switch as indicated in the wiring map. Both are necessary and obligator y to obtain a correct use of the
module and guarantee your own security as it is required by the "CE" regulations.
TRANSFORMER'S WIRING MAP
Input Voltage .......................................................................... 230 V. AC.
Output Voltage ....................................................................... 12 V. DC.
Output Voltage Adjustment ..................................................... Between 10 and 15 V. DC.
Maximum Constant Output Intensity ....................................... 3,5 A.
Maximum Intensity .................................................................. 5 A.
Maximum Ripple With Load .................................................... 7 mV.
Answer Time For An Output Short-Cirucit (With Load) ............ 0,2 Sec.
Time To Recuperate Vo. After a Short-Circuit (With Load) ...... 10 Sec.
Modeule's Sizes ...................................................................... 110 x 80 x 55 mm.
Transformer's Sizes ................................................................. 85 x 75x 70 mm.
If you observe the transformer, you could note that there are 6 terminals or pins, 3 in the
15
15
www.cebek.com
5A. 12 V. D.C.
POWER SUPPLY
FE-13
TECHNICAL CHARACTERISTICS
15
15
- sat@cebek.com
13