CEBEK FE-8 Manual

The FE-8 module is a +/- 5 V D.C symmetrical power supply perfectly stabilised with the possibility to short-circuit it and offering +/-
500 mA. as maximum output intensity.
It includes connection terminals to facilitate the assembly and Leds to indicate its operating.
Supplied with transformer.
Do not forget to read all the information mentioned hereafter to obtain a perfect operating of the module.
TRANSFORMER'S CONNECTION :
superior part with the indication 0, 230 V A.C corresponding to the input voltage (coming form the mains) and 3 in the inferior part
with the indication 9, 0 & 9 V D.C, corresponding to the output voltage, which must be connected to the module.
Connect both cables from the mains input (230 V A.C) to the superior terminals indicated as 0 & 230. (See the General Wiring Map).
For your own security and according to the "CE" regulation, we recommend you to install a Fuse and a Switch as it is indicated in
the drawing.
TRANSFORMER'S CONNEXION
SYMMETRICAL POWER

TECHNICAL CHARACTERISTICS

Voltage. ..........................................................230 V. C.A.
Output Voltage. ..............................................± 5 V. C.C.
Maximum Constant Intensity Output. .............± 500 mA.
Maximum Intensity. ........................................± 700 mA.
Maximum Ripple with Load. ............................10 mV.
module's sizes. ...............................................100 x 69 x 25 mm.
transformer's sizes. ........................................93 x 55 x 52 mm
If you observe the transformer, you could note that there are 5 terminals or pins : 2 in the
www.cebek.com -
500mA ± 5 V.
SUPPLY
FE-8
sat@cebek.com
.