Table of Contents
Advertisement
Plug Wiring
The moulded plug on this appliance incorporates
a 13 A fuse. Should the fuse need to be replaced
an ASTA approved BS1362 fuse of the same rating
must be used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the plug must
not to be used until a replacement fuse cover has
been fitted. Colour of the replacement fuse cover
must be the same colour as that visible on the pin
face of the plug Fuse covers are availabe from any
good electrical store.
• Fiting a different plug
• As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals on
your plug, proceed as follows:
• Brown cable = L (Live)
• Blue cable = N (Neutral)
• Green/yellow cable must be connected to
ground (E)
line
• With the alternative plugs a 13 A fuse must be
fitted either in the plug or adaptore or in the
main fuse box. If in doubt contact a qualified
electrician.
C
Do not place the water tank (10)
on the base (8) while filling it with
water.
Kettle / User Manual
Lid (3) should always be closed
C
during
otherwise the kettle will not switch
off automatically.
WARNING: Do not open the lid (3)
A
as hot water could splash out. Make
sure that no water splashes onto
the base (8).
C
Let the kettle cool down between
each heating process.
WARNING: Never use petrol
A
solvents, abrasive cleaners, metal
objects or hard brushes to clean the
appliance.
A
WARNING:
appliance, base (8) or power cord in
water or any other liquid.
Descaling the kettle
Descaling extends the life of your kettle. Descaling
period depends on the water hardness of your
area.
1. Fill the heater with water up to the maximum
level and boil.
2. After the heater is switched off, unplug the
appliance.
3. Add 2 cups of white vinegar or 1 tablespoon of
citric acid into the boiled water.
4. Keep the solution in the heater for a few hours.
5. Then pour it and rinse the inner part of the
heater thoroughly.
6. Fill the heater with clean water and boil it.
7. Then empty the heater and rinse with water
again.
the
boiling
process;
Never
put
9 / EN
the
Advertisement
Table of Contents
