Turning Heater Off - Toyostove Laser 560 Installation & Operation Instructions

Laser clean heating system/vented heater, laser clean vented

Hide thumbs

Table of Contents

Laser 560_Type B_US.qxd 17.5.23 9:08 ページ 15

2. Activate Weekly Timer Operation

During operation (in ON position), press the "AUTO" button to turn on the weekly timer operation mode. However, if no

program are set, you will hear the beep sound and cannot turn on the weekly timer operation mode. Press the "▲MIN."

button or the "▼HOUR" button to change the set temperature. However, if the next program starts, the temperature will

be changed to the temperature of the next program.

During operation, press the "TIMER" button to enter the weekly timer set mode (Select the program number). If

the "TIMER" button is pressed during the setting of the weekly timer set mode, the weekly timer set mode is

turned off. Change of setting is applied as soon as the AUTO operation is turned on.

Important: This feature is for testing purpose only!

This heater can also be kept burning at desired combustion mode (High, Medium or low) manually, regardless of

room temperature.

1. Press the "▲MIN." button and "▼HOUR" button at the same time for more than three (3) seconds when ON /

OFF button is "ON".

2. P1, P2 or P3 will be displayed on the Digital Indicator;

Then select desired combustion mode by pressing "▲MIN." or "▼HOUR" button. "▲MIN." button changes

combustion mode to higher, "▼HOUR" button changes combustion mode to lower.

3. To clear, press the "▲MIN." button and "▼HOUR" button at the same time for more than (3) seconds until

normal temperature display returns.

Press ON/OFF button to "OFF" position. ON lamp will flash and will go out. Circulation fan

and blower motor continue to run for approx. three (3) minutes to cool down the heater.

Make sure ON lamp goes out when the fan stops.

MANUAL COMBUSTION

P1 = Low mode

P2 = Medium mode

P3 = High mode