Advertisement
GROUND
NECK P/U
OUTPUT
BRIDGE P/U
Diagram #8
2 Pickups
Toggle Style Switch
Volume each Pickup (Volumes are independent)
Master Tone
2 Pickups / Toggle Select Switch / 2 Volumes and 2 Tones)
Refer to Diagram #9
1) Install the Pickups and route the cables to the control cavity.
If the cables are too long, wind up the excess and keep it under the pickup.
2) Mount the Volume and Tone controls into the body
Plug both Neck and Bridge pickup cables onto the Volume Controls as shown.
Plug a connect cable from the Bridge (BR) Volume control to the Pickup Buss
(Position 1).
Plug a connect cable from the Neck (NK) Volume control to the Pickup Buss
(Position 2).
3) Plug a connect cable from the Bridge (BR) Volume control to the Bridge (BR) Tone
control as shown.
4) Plug a connect cable from the Neck (NK) Volume control to the Neck (NK) Tone
control as shown.
GROUND
NECK P/U
OUTPUT
BRIDGE P/U
Diagram #9
2 Pickups
2 Volume (either volume will act as a master)
2 Tone
Toggle Style Switch
F-MF SET Instructions Page 4
FROM NECK PICKUP
FROM BRIDGE PICKUP
TO STRING GROUND
SEE DIAGRAM #5
FROM NECK PICKUP
FROM BRIDGE PICKUP
MASTER
OUTPUT CABLE
NK VOLUME
BR VOLUME
5) Strip the insulation from the switch wires and Insert them into the GREEN
Terminal Block and tighten the screws with a small screwdriver.
The Bridge pickup goes to the BR Terminal
The Neck Pickup goes to the NK Terminal
The Output of the switch goes to the O Terminal
If there is a ground wire coming from the switch, insert it into one of the black
terminals on the terminal block.
6) Plug the output cable onto the Pickup Buss (Position 3) and push the
connectors onto the jack as shown.
WHITE wire onto the TIP (T) contact,
BLACK wire onto the SLEEVE (S) contact
We suggest that you plug in the instrument and test it before closing the
control cavity.
OUTPUT CABLE
NK VOLUME
BR VOLUME
TO STRING GROUND
SEE DIAGRAM #5
TONE
S
T
6
5
4
3
2
1
OUTPUT
S
T
NK TONE
BR TONE
OUTPUT
Advertisement
