Advertisement
Quick Links
INSTALLATION INFORMATION
EMG MODEL: MARTY FRIEDMAN - MF SET
SPECIFICATIONS:
Logo Color
Magnet Type
Gauss Strength
Inductance (Henries) (1)
DC Resistance (kOhm)
Q
Resonant Frequency (KHz) (2)
Resonant Frequency (KHz) (3)
Impedance at Resonance (kOhm) (2)
(1) Wired in Series
(2) Loaded with 500K Volume and Tone with a 20' (6M) cable
(3) Loaded with 1 MegOhm / 47pf
Installation notes:
All EMG-Passive Pickups are compatible with each other. The connector system is an easy method of installation, avoiding the need to solder.
EMG Accessory Circuits like the VLPF, EXG, SPC or RPC Controls can be added to any EMG Passive System, all EMG Accessory circuits have
buffered inputs and can be used on either passive or active pickups.
SPECIAL NOTE: The Red Wire of the HZ Pickup is NOT for battery power, it is a coil wire.
Included IN THE MF SET:
2 VOLUME CONTROLS (500K)
2 TONE CONTROSL (500K)
.235
(6)
.390
.310
(8)
(10)
MONO OUTPUT
BRIDGE GROUND
JACK
CONNECTOR
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
© 2016 Copyright EMG INC. All Rights Reserved.
MODEL:
MF-N5 (NECK)
Gold
Gold
Alnico 5
Alnico 5
275
275
4.3
8.58
7.55
16.2
.44
.39
3.00
2.25
4.54
3.39
81
121
ADJUSTMENT
SCREWS & SPRINGS
2 PICKUP IN/ OUT
BATTERY BUSS
B245
1.50
(38.1)
MF-B5 (BRIDGE)
.900
(22.8)
FINGERBOARD PICKUP
+
WHITE
SCREW BOBBIN
+
BLACK
STUD BOBBIN
PICKUP CABLES 15" (30cm)
4 CONNECT CABLES 5.5" (14cm)
OUTPUT CABLE 6" (15cm)
BRIDGE GROUND WIRE 6" (15cm)
2.75
(69.8)
.39 (9.9) TYP
3.09
(78.5)
3/48 MOUNTING HOLES
EMG COIL WIRING
BRIDGE PICKUP
COIL 1
_
+
GREEN
BLACK
COIL 2
_
+
RED
WHITE
.725 (18.4)
COIL 2
_
RED
STUD BOBBIN
COIL 1
_
GREEN
SCREW BOBBIN
Advertisement
Related Manuals for EMG MARTY FRIEDMAN MF Series
Summary of Contents for EMG MARTY FRIEDMAN MF Series
- Page 1 Warranty All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This warranty covers only those pickups and accessories sold by authorized EMG Dealers.
- Page 2 If you are installing two pickups go to page 3 and begin there. Installation (One Pickup Guitars): 1) Plug the pickup cable onto the EMG Pickup header as shown in Diagram #1 and route the cable to the control cavity.
- Page 3 Installation (Two Pickup Guitars with Selection switch): Start your installation by: Start your installation by: Guitars with two pickups and a selection switch will use the EMG B245 Pickup Buss. 1) Remove the strings 1) Remove the strings The Pickup Buss is a convenient way to wire your guitar without soldering.
- Page 4 GROUND OUTPUT NECK P/U MASTER TONE OUTPUT BRIDGE P/U OUTPUT CABLE NK VOLUME FROM NECK PICKUP Diagram #8 2 Pickups Toggle Style Switch Volume each Pickup (Volumes are independent) BR VOLUME Master Tone FROM BRIDGE PICKUP TO STRING GROUND SEE DIAGRAM #5 2 Pickups / Toggle Select Switch / 2 Volumes and 2 Tones) Refer to Diagram #9 1) Install the Pickups and route the cables to the control cavity.