Fcc Information - RCA RSA180 User Manual

UG-2501 4/9/99 9:48 AM

FCC Information

RCA Information
This device generates and uses radio frequency (RF)
energy, and if not installed and used properly, this
equipment may cause interference to radio and televi-
sion reception.
This equipment has been type tested and found to
comply with the specifications in Subpart J of Part 15
of FCC Rules. These rules are designed to provide rea-
sonable protection against radio and television inter-
ference in a residential installation. However, there is
no guarantee that interference will not occur in par-
ticular installations.
If this equipment does cause interference to radio or
television reception (which you can determine by
turning the equipment off and on), try to correct the
interference by one or more of the following meas-
ures:
• Reorient the receiving antenna (that is,
the antenna for the radio or television
that is "receiving" the interference).
• Move the unit away from the equipment
that is receiving interference.
• Plug the unit into a different wall outlet
so that the unit and the equipment
receiving interference are on different
branch circuits.
If these measures do not eliminate the interference,
please consult your dealer or an experienced radio/tel-
evision technician for additional suggestions.
Also, the Federal Communications Commission has
prepared a helpful booklet, "How To Identify and
Resolve Radio TV Interference Problems." This booklet
is available from the U.S. Government Printing Office,
Washington, DC 20402. Please specify stock number
004-000-00345-4 when ordering copies.
For Your Safety
The AC power plug is polarized (one blade is wider
than the other) and only fits into AC power outlets
one way. If the plug won't go into the outlet com-
pletely, turn the plug over and try to insert it the other
way. If it still won't fit, contact a qualified electrician
to change the outlet, or use a different one. Do not
attempt to bypass this safety feature.
CAUTION: TO PREVENT ELECTRIC SHOCK,
MATCH WIDE BLADE OF PLUG TO WIDE
SLOT, FULLY INSERT.
Page 15
For Your Records
In the event that service should be required, you may
need both the model number and the serial number.
In the space below, record the date and place of pur-
chase, and the serial number:
Model No. RS2501/A180/A185
RS2502/RS252KM/A280/A285
RS2503/RS253TK/A380/A385
RS2505/RS255KM
RS2506
RS2507/A580
Remote Control No. CRK291C1
Date of Purchase
Place of Purchase
Serial No.
Service Information
This product should be serviced only by those specially
trained in appropriate servicing techniques. For
instructions on how to obtain service, refer to the
warranty included in this Guide.
Altima Specifications
CAUTION!
Invisible laser radiation when open. Avoid exposure
to beam. Class 3B laser product. This system must be
opened only by qualified technicians to prevent
accidents caused by the laser beam.
LASER λ = 780 nm, P max = 5 mW
Information Labels
These are located behind and inside the set. This unit
complies with international safety specifications IEC
65 (VDE 0860) and with European directives,
82/499/EWG (VDE 0875).
In accordance with the ratings plate, this system com-
plies with current standards concerning electrical
safety and electromagnetic compatibility.
GB
12