Operation - Graco LazerVac 25M858 Operation, Parts

Operation

Operation
1. Ensure all LazerVac motor switches are turned to
"OFF". Plug vacuum into grounded power source.
2. Turn Auto Filter Cleaner Power Switch to "ON".
Ensure the sound of the Filter Cleaner Bar is heard
contacting the inside of the filter. If no sound is
heard, replace the Plastic Inserts on the cleaning
bar. See page 18.
3. After 10 seconds, turn on a Vacuum Motor Switch.
Turn on additional vacuum motors if more vacuum
power is needed.
4. LazerVac is now ready for dust collection from the
GrindLazer or other removal equipment.
5. Use the vacuum accessories shown in the section
titled Main Assembly Diagram (LazerVac), page
12 to pick up dust from the ground between grinding
passes.
8
Emptying Collection Tanks and
Bags
DUST HAZARD
Grinding concrete and other surfaces can create dust
that contains hazardous substances. To reduce the
risk of serious injury:
• Respirator must be worn when emptying or
cleaning Dust Collection Tanks or bags.
• Follow local ordinances and regulations for
disposal.
LazerVac and Cyclone 20 and 32
1. When Dust Collection Tanks are full, turn off all
vacuum motors and leave Auto Filter Cleaner power
switch to "ON". After 2 minutes of cleaning the
vacuum filters, turn off cleaning switch and unplug
vacuum from power source.
2. Put on a respirator.
3. If LazerVac is full, remove Dust Collection Tank by
pulling up on the Engagement Lever.
4. If Cyclone separator is full, remove the Separator
Lid.
5. Remove the Dust Bag Holder from the tank.
6. Gather and secure the top of the collection bag. Lift
and remove the collection bag, tie up and then
dispose. Follow local ordinances and regulations for
disposal.
3A5576E