Diagram Of Outdoor Unit Installation - Sanyo CLM1972 Installation Instructions Manual

06-060 KMS0772-2472 ENG 3/17/06

Diagram of Outdoor Unit Installation

2-6.
Never install only a single indoor unit.
Ensure 6"(15cm)
of space if a
drain hose is to
be used.
Base (not provided)
(concrete or similar material)
2:50 PM Page 12
Be sure to connect indoor and outdoor units only in
combinations that are listed in the catalog or in the
combination table that was provided with the outdoor unit.
(Use caution. Connecting any other model may result in
operation failure and malfunction.)
The dimensions indicated by in the figure below are
spaces that are required in order to maintain
performance. Install in a location where the dimensions
indicated by are ensured, and where 2 or more faces
of the unit are unobstructed. In principle, the top direction
should be unobstructed.
Fasten with anchor bolts
(not provided)
(3/8" or M10, 4 locations)
Service space
Power breaker
D
C
B
A
Ground
wire
(not
provided)
Fig. 7
12
Indoor unit D
Indoor unit C
Indoor unit B
Indoor unit A
Access panel C