Basic Operation Guide; Startup & Shutdown; Startup; Shutdown - TechVision NS4P1P8 Manual

4 channel recorder 1u

Table of Contents

Basic Operation Guide

2.1 Startup & Shutdown

Please make sure all the connections are done properly before you power on the unit. Proper

startup and shutdown are crucial to expending the life of your device.

① Connect the output display device to the VGA/HDMI interface of the NVR.

② Connect with the mouse and power. The device will boot and the power LED would turn

blue.

③ A WIZARD window will pop up (you should select the display language the first time you

use the NVR). Refer to 3.1 Startup Wizard for details.

You can power off the device by using remote controller or mouse.

By remote controller:

① Press the Power button. This will take you to a shutdown window. The unit will power off

after a while by clicking the "OK" button.

② Disconnect the power.

By mouse:

① Click StartShutdown to pop up the Shutdown window. Select "Shutdown" in the

window. The unit will power off after a while by clicking the "OK" button.

② Disconnect the power.

① It uses two AAA size batteries.

② Open the battery cover of the remote controller.

③ Place batteries. Please take care the polarity (+ and -).

④ Replace the battery cover.

Key points to check in case the remote doesn't work.

1. Check batteries polarity.

2. Check the remaining charge in the batteries.

3. Check IR controller sensor for any masking.

If it still doesn't work, please change a new remote controller to try, or contact your dealers.

You can just turn the IR sensor of the remote controller towards the IR receiver of the NVR to

control it when you are controlling multiple devices by remote controller.

There are two kinds of remote controller. The interface of remote controller is shown as below.

2 Basic Operation Guide

NVR User Manual

Table of Contents