Table of Contents
Advertisement
Hook the rear retainers with the hook into the top
3.
hole
and push them into the bottom hole
23 Troubleshooting
You can rectify minor faults on your appliance yourself.
Read the troubleshooting information before contacting
after-sales service. This will avoid unnecessary costs.
WARNING ‒ Risk of injury!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
If the appliance is defective, call Customer Service.
▶
→ "Customer Service", Page 31
23.1 Malfunctions
Fault
The appliance is not
working.
"Sprache Deutsch"
appears in the dis-
play.
The operation does
not start or is inter-
rupted.
Appliance does not
heat up.
Cause and troubleshooting
The circuit breaker in the fuse box has tripped.
Check the circuit breaker in the fuse box.
▶
There has been a power cut.
Check whether the lighting in your kitchen or other appliances are working.
▶
Electronics fault
Disconnect the appliance from the power supply for at least 30 seconds by switching off
1.
the fuse.
Reset the basic settings to the factory settings.
2.
→ "Basic settings", Page 21
There has been a power cut.
Configure the initial configuration settings.
▶
→ "Performing initial start-up", Page 12
Different causes are possible.
Check the notifications that appear on the display.
▶
→ "Displaying information", Page 14
Malfunction
Call the after-sales service.
▶
→ "Customer Service", Page 31
Demo mode is switched on.
Briefly disconnect the appliance from the power supply by switching the circuit breaker in
1.
the fuse box off and then on again.
Switch off demo mode in the basic settings within approx. 5 minutes.
2.
→ "Changing the basic settings", Page 22
22.3 Attaching the rails
.
Set the rear rail at an angle, hooking it into the re-
1.
tainers at the top and bottom
Pull the rail forwards
2.
3.
Hook in the rail at the front
WARNING ‒ Risk of electric shock!
Improper repairs are dangerous.
Repairs to the appliance should only be carried out
▶
by trained specialist staff.
Only use genuine spare parts when repairing the
▶
appliance.
If the power cord of this appliance is damaged, it
▶
must be replaced by the manufacturer, the manufac-
turer's Customer Service or a similarly qualified per-
son in order to prevent any risk.
Troubleshooting en
.
.
and press it down
.
29
Advertisement
Table of Contents
