Please read this user manual first! Dear Customer, Thank you for prefering a Beko product. We hope that your product which has been manufac- tured with high quality and technology will give you the best results. We advise you to read through this manual and the other accompanying documentation carefully before using your product and keep it for future reference.
Important instructions for safety and environment This section contains safety instructions that will help protect from risk of personal injury or property damage. Failure to follow these instructions shall void any warranty. 1.1 General safety • The dryer can be used by children at and above 8 years old and by persons whose physical, sensory or mental capabilities were not fully developed or who lack experience and knowledge provided that they are...
Page 4
Important instructions for safety and environment 1.1.1 Electrical safety Electrical safety instructions should be followed while electrical connection is made during the installation. The appliance must not be supplied through an external switching device, such as a timer,or connected to a circuit that is regularly switched on and off by utility.
Important instructions for safety and environment Damaged mains cable should be changed notifying the Authorized Service. If the dryer is faulty, it must not be operated unless it is repaired by an authorized service agent! There is the risk of electric shock! 1.1.2 Product safety Superheating of the clothes inside of the dryer can occur if you cancel the programme or in the event...
Page 6
Important instructions for safety and environment Below specified laundry or items must not be dried in the dryer due to the fire hazard: • Garments or pillows bolstered with rubber foam (latex foam), shower bonnets, water resistant textiles, materials with rubber reinforcement and rubber foam pads.
Important instructions for safety and environment • Never attempt to repair the dryer by yourself. Do not perform any repair or replacement procedures on the product even if you know or have the ability to perform the required procedure unless it is clearly suggested in the operating instructions or the published service manual.
Important instructions for safety and environment Installation Table for Washing Machine and Dryer Washing Machine Depth Dryer Depth 62 cm 60 cm 54 cm 50 cm 49 cm 45 cm 40 cm Can be Can be installed 54 cm installed Cannot be installed Cannot be Can be installed...
Important instructions for safety and environment 1.5 Compliance with the WEEE regulation and disposing of the waste product This product complies with EU WEEE Directive (2012/19/EU). This product bears a classification symbol for waste electrical and electronic equipment (WEEE). This product has been manufactured with high quality parts and materials which can be reused and are suitable for recycling.
Important instructions for safety and environment 1.8 Technical Specifications Height (Min. / Max.) 84,6 cm / 86,6 cm* Width 59,5 cm Depth 60,9 cm Capacity (max.) 8 kg** Net weight (plastic front door 49 kg usage) Net weight (glass front door 51 kg usage) Voltage...
Your Dryer 2.1 Package Contents 1. Water drain hose * 2. Filter drawer spare sponge* 3. User Manual 4. Drying basket* 5. Drying basket user manual* *It can be supplied with your machine depending on its model. Dryer / User Manual 11 / EN...
Installation Before the calling the nearest Authorized • The rear surface of the tumble dryer Service for the installation of the dryer, en- shall be placed against a wall. sure that electrical installation and water on the Do not place the dryer drain is appropriate referring to the user’s power cable.
Installation 3.3 Connecting to the drain 3.4 Adjusting the feet In products equipped with condenser unit, • In order to ensure that the dryer water accumulates in the water tank during operates more silently and vibration- the drying cycle. You should drain accumu- free, it must stand level and balanced lated water after each drying cycle.
Installation 3.7 Warnings about sounds It is normal to hear a metallic noise from the compressor some- times during operation. Water collected during operation is pumped to water tank. It is nor- mal to hear pumping noise during this process. 3.8 Changing the illumination lamp In case an illumination lamp is used in your...
Preparation 4.1 Laundry suitable for drying in the dryer • Always obey the instructions given on the garment tags. Dry only the laundry having a label stating that they are suitable for drying in a dryer and make sure that you select the appropriate programme.
Preparation • Clean the lint filter before or after each Following weights are given as examples. drying cycle. (See 6.1 Cleaning Lint Approximate Laundry Filter / Loading Door Inner Surface) weights (g)* • Clean the filter periodically when there Cotton quit covers is visible air collection on it or when 1500 (double)
Operating the product 5.1 Control panel Program selection knob Remaining duration indicator On/Off button 4. Start/pause button End duration button Sound warning button 5.2 Screen symbols Child-proof Filter Tank Volume up Anti Mute full lock cleaning Creasing Dryer / User Manual 17 / EN...
Page 18
Operating the product 5.3 Preparing the machine 5.5 Main programs Plug in the machine The main programs are given below based on Place laundry inside the machine. fabric type. Press the On/Off button. • Cotton 4. When your machine turns on for the first Dry durable laundry with this program.
Page 19
Operating the product • BabyProtect Program used for baby clothing with can be dried approval on the label. Very little dampness might remain on the shirts after the program. It is recommended that you do not leave the shirts in the drying machine.
Operating the product 5.7 Program selection and consumption table Capacity Spin speed in wash- Approximate amount of Drying time Programs (kg) ing machine (rpm) remaining humidity (minutes) Cottons / Coloreds A Extra dry 1000 % 60 A Cupboard dry 8 / 4 1000 % 60 179 / 104...
Operating the product 5.8 Auxiliary functions Loading door open Start/Pause led blinks when the loading door Sound warning cancel of the drying machine is open. Drying machine makes sound warnings 5.10 End duration when the program is completed. If you don’t want sound notifications, press the “Sound You can delay the end duration of the pro- Notification”...
Operating the product Canceling the end duration function A warning sound is heard when any button is pressed (except for On/Off button) or the If you want to cancel the end duration set- Program Selection knob is turned while the ting countdown and start the program right away: child lock is active.
Operating the product If a new program is selected by changing the position of the program selection knob while your machine is in stand-by mode, the running program ends. Do not contact the inner surface of the drum when adding or removing laundry during a continuing program.
Maintenance and cleaning Service life of product extends and frequent- • A layer can build up on the filter pores ly experienced problems will be reduced if it that can cause clogging of the filter after is cleaned at regular intervals. using the dryer for a while.
Maintenance and cleaning 6.2 Cleaning the sensor 6.3 Draining the water tank There are dampness sensors in the dryer Dampness of the laundry is removed and that detect whether the laundry is dry or not. condensed during drying process and the To clean the sensors: water that arise accumulates in the water •...
Maintenance and cleaning • Open the filter drawer by pressing the If the direct water draining is used red button. as an option, there is no need to empty the water tank. 6.4 Cleaning the filter drawer Lint and fiber that could not be captured by the lint filter are blocked in the filter drawer behind the kick plate.
Maintenance and cleaning 6.5 Cleaning the evaporator • Close the filter drawer as to lock the red button. Clean the lint accumulated on the fins of the evaporator located behind the filter drawer with a vacuum cleaner. • Place the filter drawer back into its place, turn the filter drawer cover in the arrow direction and close it securely.
Troubleshooting Drying process takes too much time. • Pores of the lint filter are clogged. >>> Wash the lint filter with warm water. • Filter drawer may be blocked>>>clean the foam inside the filter drawer. • Ventilation grids on the front side of the machine are blocked. >>> Remove the objects (if any) that block ventilation in front of the ventilation grids.
Page 29
Troubleshooting Drum lighting does not turn on. (On models with lamp) • Dryer is not switched on with the On / Off button. >>> Make sure that the dryer is switched on. • Lamp is defective. >>> Call Authorized Service Agent to have the lamp replaced. End/Anti-creasing symbol is on.