powermesh PMBC2 Manual

Let's get
connected.
Single and Dual
Blind Controllers.
1

Important - Read before installing.

Must only be installed by a
LICENSED ELECTRICIAN
to local wiring regulations.
Powermesh devices must only be
connected with the Active and Neutral
from the same RCD.
AVOID THE RISK OF ELECTRIC SHOCK
Once the product has been fastened to
the wall, ensure the screw caps are
inserted firmly into place over the screw
mounting holes.
2

Using the Blind Controller.

Blind Switch
• Single press to
open or close
• Press to stop
Open / Stop
Close / Stop
LED indicator
pulses when
moving.
Mounting Screws
Included on rear of device.
3

Identifying the Blind Controllers.

2 Button
PMBC2
Open
Close
Blind 1
4 Single Blind Controller.
Specifications
NEUTRAL
Part Number
White PMBC2
Black PMBC2BK
Compatible Loads
Small motor
rating: M.40
Rated Loads
600W (2.5A) max,
230V ~ 50Hz
Dual Blind Controller.
5
Specifications
NEUTRAL
Part Number
White PMBC4
Black PMBC4BK
Compatible Loads
Small motor
rating: M.40
Rated Loads
600W (2.5A) max per
channel, 230V ~ 50Hz
Powermesh_Blind_Controller_Installation_Instructions.pdf 230201
Failure to follow these
instructions can result in
serious injury or death.
Surge protection is recommended at
the main switchboard. Products
damaged by power surges are not
covered by warranty.
Megger testing may lead to low readings
due to electronic components so
disconnect all electronic devices before
taking a reading. Install the included
warning sticker with circuit detail in the
main electrical switchboard.
Status Indicator
See overleaf for the meaning
of each colour status.
Factory Reset
RESET
Press until indicator flashes
blue to restore factory
settings. When the indicator
turns blue, it's ready to pair.
(remove cover)
MAC ID
Unique product
serial number.
(remove cover)
Snap on cover
4 Button
PMBC4
Blind 1 Blind 2
Open Open
Close Close
Blind 2 Blind 1
CLOSE
Blind 1
OPEN
ACTIVE
CLOSE
Blind
2
OPEN
CLOSE
Blind
1
OPEN
ACTIVE
BLIND 2 BLIND 1
Pair and setup with Zimi.
6
• Download the Zimi App.
• Choose 'Add New Device'.
• Follow the on screen instructions.
Download Zimi App.
Point your phone
camera at the QR code
to open the app store.
7
Zimi Cloud Connect.
Enjoy the full experience
with all your Zimi devices.
Internet connection required.
Want to learn more or need help?
8
Enjoy all the features to make your life easier.
Visit our website for tips, tricks and help.
support.zimi.life
Smart Blinds
Switch, app and Automatically
voice control. open and close.
Status Indicator.
9
Ready to pair.
Blue
'Add New Device' in Zimi to pair and complete setup.
Setup is complete.
White
This device has been paired and setup completed.
White
Action in progress.
pulsing
This lets you know an automatic function is being activated.
Blue & White Identify device.
pulsing
This shows the device when updating its settings.
Device problem.
Red
Please refer to support to resolve the problem.
Indicator is off.
Off
The status indicator can be turned o and on in settings.
Manufacturer's Warranty
This product has been manufactured to the highest quality standards. This product is warranted
to the original purchaser and is not transferable. The product is guaranteed to be free from defects in workmanship and parts for a period
of 1 Year from the date of purchase. Defects that occur within this warranty period, under normal use and care will be repaired, replaced or
refunded. The benefits conferred by this warranty are in addition to all other rights and remedies of the consumer under a Commonwealth,
State and Territory laws in relation to the goods or services to which this warranty relates and Australian Consumer Law. Risk in regard to
the product to be repaired shall at all times remain with the Purchaser. The warranty is given on the condition that the product to which
it applies is used for the purpose and in the manner intended by its construction and for no other purposes whatsoever. Zimi Ltd shall not
be responsible for damage of any kind, caused by accidents, power surges, electrical storm damage, incorrect power current, infestation
(vermin or insect), incorrect installation, incorrect electricity or plumbing installation, improper use of controls or failure to use the unit
in accordance with the operating instructions, general misuse or abuse or from normal wear and tear. Any attempt by an unauthorised
person to repair or tamper with the equipment shall render the warranty null and void. Goods presented for repair under this warranty may
be replaced by refurbished goods of the same type rather than being repaired. Refurbished parts may be used to repair the goods. Zimi
Ltd's liability under this warranty is limited to the replacement and/or repair of the defective parts within the warranty period and does not
extend to installation or removal of the product. Acceptance of liability by Zimi Ltd contained herein is to the exclusion of any other remedy
whatsoever and howsoever arising in respect of any equipment to which it applies.
Proof of Purchase
Please keep your purchase docket or receipt as proof of purchase and as proof of the date on which the purchase
was made. The purchase docket or receipt must be presented with the warranty when making a claim under this warranty. Failure to produce
documentary proof of the date of original acquisition by the original Purchaser will result in a charge being levied for work done, labour and
parts supplied. Likewise a charge will be made for any calls following warranty claim where no fault is found with the unit.
Service during the warranty period
The first point of contact for product issues is the place of purchase. The product must be
returned to the original place of purchase for product repair, replacement or refund. Please ensure the product is properly packaged so
as to ensure that no damage occurs to the product during transit and make sure that you have included an explanation of the problem.
In the event of goods requiring repair under manufacturer's warranty the owner is responsible for the cost of transportation. Should the
goods be found to be in sound working order the owner might be charged a fee. This warranty is given by Zimi Ltd, 14 Millennium Circuit,
Helensvale, QLD 4212.
Safety Warnings
Read all instructions and safety information. All electrical work must only be undertaken after disconnection of the
power by removing fuses or turning off the circuit breaker, to ensure all pole disconnection from the electrical supply. All electrical
work must be carried out by a licensed and qualified electrician and in accordance to AS/NZS 3000 Wiring Rules and applicable
local authority regulations. This product is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use
of the product by a person responsible for their safety. Young children should be supervised to ensure they do not play with the unit.
Do not cut or notch joists, beams and rafters to install the unit. Do not damage hidden electrical wiring or utilities when cutting. The
product must be installed so switches and other controls cannot be touched by a person in the bath or shower. Do not install the product
in a location where water will splash onto it. Check and confirm that all connections are proper and secure to prevent causing property
damages or injury. Do not install outdoor where it could be exposed to water or moisture (indoor use only).
Trademarks
Zimi and Powermesh and their respective logos are registered trademarks of Zimi Ltd. Google and Google Play are
trademarks of Google LLC. Amazon, Alexa and all related logos are trademarks of Amazon.com, Inc. or its affiliates. Apple, the Apple logo,
Apple Watch and iPhone are trademarks of Apple Inc., registered in the U.S. and other countries. App Store is a service mark of Apple Inc.,
registered in the U.S. and other countries.
Copyright © 2022 Zimi Ltd. All rights reserved.
14 Millennium Circuit
Helensvale QLD 4212
Australia.
www.zimi.life
Remote access
anywhere.
Voice control
hands free.
Sunrise & Sunset
schedules.
Schedules Double press
Control all your
connected blinds.