Factory Default Settings - Marathon Power Vault HP Series User Manual

Caution! Local safety requirements may require a separate external Emergency Power Off that opens
output circuit breakers, and if so, use figures 2 to 4 for proper installation. Refer to local wiring rules.
• Should computer or alarm connections be used, use connections according to chapter 6 of the
manual provided with that option. The connections can be referred to on the rear panel.
• The installation is now complete.
Power for UPS
6000VA
10000VA
5.5 Default Settings at the Factory
On the LCD display you will find several of the UPS parameters to select. Default settings are
as follows:
Settings
Output Voltage Setting
Input/Bypass Voltage
Input/Frequency
HE Mode Setting
Free Run Mode
Bypass Enable/Disable at free run
mode
Alarm silence
Site wiring alarm
External Battery pack setting
You may change default settings, but we recommend that this is done after installation and
before starting up loads. Read UPS configurations in chapter 7.2 for more information.
Circuit Breaker Wiring AWG or mm
40A 10 AWG or 5.5mm
60A 8 AWG or 8 mm
Fig. 2
Selection
208/220/230/240 Vac
±10%
+10/-15%
+15/-20%
±2%
±5%
±7%
On/Off
On/Off
Disable/Enable
On/Off
Enable/Disable
0, 1, 2
20
2
2
2
Factory default
230V (FOR HV
series)
+10/-15%
±5%
Off
On
Disable
Off
Disable
0