Table of Contents
Advertisement
RFR Delay (CH B)
Configure RFR Delay for Channel B.
ODT Setting
ODT WR (A1)
Configure the memory on die termination resistors' WR for channel A.
ODT WR (B1)
Configure the memory on die termination resistors' WR for channel B.
ODT NOM (A1)
Use this to change ODT (CH A) Auto/Manual settings. The default is [Auto].
ODT NOM (B1)
Use this to change ODT (CH B) Auto/Manual settings. The default is [Auto].
ODT PARK (A1)
Configure the memory on die termination resistors' PARK for channel A.
ODT PARK (B1)
Configure the memory on die termination resistors' PARK for channel B.
COMP Setting
RCOMP0: DQ ODT (Read)
Default is 121.
RCOMP1: DQ /CLK Ron (Drive Strength)
Default is 75.
RCOMP2: CMD/CTL Ron (Drive Strength)
Default is 100.
DQ ODT Driving
Adjust ODT Driving for better signal. Default is 60.
DQ Driving
Adjust DQ Driving for better signal. Default is 26.
Command Driving
Adjust Command Driving for better signal. Default is 20.
28
Advertisement
Table of Contents
