Auto Show; Static Color; Manual Color; Master/Slave Mode - Prolights Tribe LUMIPIX12TRIIP User Manual

8

3.4 AUTO SHOW

This fixture has a built-in automatic program. To access this, please see the below instructions:
• Press the button MENU so many times until shows [P--], then press the button ENTER.
• Using UP/DOWN button, select one of the programs [P1 - P6].
• Press the button ENTER to confirm.
• Press the button MENU until [S--] appears on the display.
• Use the button UP/DOWN to select the auto programs speed [S001 - S100] (slow-fast).
• Press the button ENTER save the setting.

3.5 STATIC COLOR

This fixture has the ability to accept custom static color settings. Access these chases via the control panel
on the back of the fixture.
• Press the button MENU so many times until shows [C--], then press the button ENTER.
• Using UP/DOWN button, select one of the programs [C1 - C7].
• Press the button ENTER to confirm.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.6 MANUAL COLOR

This mode allows to combine the colors red, green and blue (r, g, b).
• Press the button MENU so many times until the display shows [U--], then press the button ENTER.
• Select the color [r, g, b] through the buttons UP/DOWN.
• Press the button ENTER to confirm.
• Using UP/DOWN button, select the desired color value [000 - 255].
• Press ENTER button to continue to the next color.
• Continue until the desired mix is obtained.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.

3.7 MASTER/SLAVE MODE

This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave.
• Set on master fixture the desired program (see section 3.4).
• Press the button MENU so many times until the display shows [Slr] and press the button ENTER.
NOTE
• Sync feature: [Slr] is [A1]
• Asynchronous serial feature
- Master settings the number of [Slr] is for the online units;
- Slave set the online location by [Slr]
Example for 10 units
1
master slave
A10 A2
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 11).
LUMIPIX12TRI IP
2 3
slave
A3
... 10
... slave
... A10