Installation; Mounting - Prolights Tribe LUMIPIX12TRIIP User Manual

Table of Contents

Available languages

- 2 - INSTALLATION

LUMIPIX12TRI IP may be set up on a solid and even surface. The unit can also be mounted upside down to

a cross arm. For fixing, stable mounting clips are required. The mounting place must be of sufficient stabil-

ity and be able to support a weight of 10 times of the unit's weight.

When carrying out any installation, always comply scrupulously with all the regulations (particularly re-

garding safety) currently in force in the country in which the fixture's being used.

• Install the projector at a suitable location by means of the mounting bracket (2).

• Always additionally secure the projector with the safety rope from falling down. For this purpose, fas-

ten the safety rope at a suitable position so that the maximum fall of the projector will be 20 cm.

• Adjust the projector and use the screw to slightly release or tighten the locking mechanism of the

bracket if is necessary.

LUMIPIX12TRI IP

Fig.2

Table of Contents

Table of Contents