Table of Contents
Advertisement
Operating the appliance
en
Placing laundry into the drum
:
Warning
Danger of death!
Items of laundry pretreated with
cleaning agents that contain solvents,
e.g. stain remover/cleaning solvent,
may cause an explosion after being
loaded into the washing machine.
Hand-rinse these items of laundry
thoroughly beforehand.
Notes
Mix items of laundry of varying sizes.
■
Laundry items of different sizes
distribute themselves better during
the spin cycle. Individual laundry
items may cause an unbalanced
load.
Observe the maximum specified
■
load. Overfilling adversely affects the
washing result and promotes
creasing.
Unfold presorted laundry items and
1.
place them in the drum.
Make sure that no items of laundry
2.
are trapped between the door and
the rubber seal, and close the door.
The A button indicator lamp flashes
and the programme settings appear in
the display panel.
26
Measure and add detergent
and care products
The washing machine doses your
detergent and fabric softener
automatically in most programmes.
The intelligent dosage has been preset
at the factory for all programmes in
which it can be used.
You can use these default settings or
change them. ~ Page 24
In addition to intelligent dosage,
cleaning aids (e.g. stain remover) can
be added manually to compartment
v u, if necessary. ~ Page 32
For programmes that cannot be used
with intelligent dosage, or if you would
prefer to dose manually (in which case
set intelligent dosage to "off" ö), add
detergent to compartment v u.
~ Page 32
Change the programme
default settings
You can use the default settings for
each washing cycle or change them.
To do this, repeatedly press the
corresponding button until the required
setting is displayed.
Pressing and holding the buttons
Note:
automatically runs through the setting
values until the last one. Then press the
button again and you will be able to
change the setting values again.
The settings are activated without
needing to be confirmed.
Advertisement
Table of Contents
