Salente AirFit Manual page 34

 Always clean product surfaces that come into contact with food or foodstuffs
according to the instructions in this user manual.
 Before connecting the product to an electrical outlet, make sure that the voltage
on the product's rating plate matches the voltage in your electrical outlet.
 Fully unwind the power cord before using the product.
 Do not wrap the power cord around the product.
 Do not connect or disconnect the product's power cord from the electrical outlet
with wet hands.
 Make sure that the fork of the power cord does not come into contact with
moisture, water or other liquids. If this still happens, dry the fork carefully before
using it again.
 Do not disconnect the product from the power outlet by pulling the power cord.
Damage to the power cord or electrical outlet could occur. Disconnect the power
cord from the power outlet by pulling the plug.
 Do not place heavy objects on the power cord. Make sure that the power cord
does not hang over the edge of the table or touch hot surfaces or sharp objects.
 Always clean the power cord with a dry cloth only, never wash it with water.
 Always switch off and unplug the product when not in use, when left unattended
and before cleaning, maintenance or storage.
 Keep the supply cable dry.
 Only connect the product to a properly grounded outlet.
 Do not plug the product into an extension cord.
 If the supply cable is damaged, have it replaced by a qualified service centre to
avoid a dangerous situation. It is forbidden to use the product with a damaged
power cord.
 This product is not intended to be controlled by a programmer, external time
switch or remote control.
 Always switch off the product and disconnect it from the power outlet after use.
 Do not use the product near flammable materials such as dish towels, curtains,
drapes, etc.
 Do not use the product near objects or surfaces that can be damaged by steam
(e.g. walls, wallpaper, pictures, hanging cabinets, shelves, etc.).
 When the product is in operation, the temperature of some of its surfaces may be
higher. Do not touch heated surfaces of the product or its accessories or you may
be burned.
 During operation, a clear space of at least 15 cm must be left on all sides of the
product to ensure sufficient air circulation.
 Do not cover the ventilation openings of the product.
34