Advertisement
RECESSED TRACK (WITHOUT WINGS) INSTALLATION
Accessories required for recessed track(without wings) installation:
NAME
NO
Recessed Kit
1.
4x30mm Tapping
2.
Screw
1. Before you install the recessed track, please refer to the hole position mapping diagram(Fig11),
dimension spacing table of the recessed fixing parts and track cut out size in the installation area.
Track installation - Hole position marking diagram
FIG 11
2. Before installating please refer to the table
for track cut out size, installation & marking
position (Fig 12).
4. Install the track into the ceiling, and fix the
track to the fitting using M7 screws. Ensure the
screws are properly installed (Fig 14).
SKU
PICTURE
7970
FIG 12
FIG 14
SIZE
Installation of recessed kit (without
wings) track only. Installation and Fixed
use black.
For track installation and fixed use.
4x30mm
RECESSED ACCESSORY DESCRIPTION:
1. The accessory is mounted on the back of the ceiling board.
2. The thickness of the board should be 8-12mm.
Dimension spacing table of hole for recessed
(without wings)magnetic track
SKU/Length
7950 / 0.5M
7951 / 1M
7953 / 1.5M
7952 / 2M
3. Insert the recessed accessories into the measur-
ing position on the back of the open ceiling. Fix the
fittings with self-tapping screws and check whether
the fittings are installed correctly. Ensure the track
is firmly installed (Fig 13).
5. Load the magnetic track lights into the track
then switch on the power to test the light (Fig 15).
2
ENGLISH
ENGLISH
DESCRIPTION
FIG 13
FIG 15
Advertisement
