Related Manuals for RS PRO RS-SI 7005
Summary of Contents for RS PRO RS-SI 7005
- Page 1 ENGLISH RS-SI 7005 60MHz Active Differential Probe x1 / x5 / x10 RS Part-No. 2539784...
-
Page 2: Safety Summary
ENGLISH Safety Summary To avoid personal injury and/or product damage, review and comply with the following safety precautions. These precautions apply to both operating and maintenance personnel and must be followed during all phases of operation, service, and repair of this probe. A WARNING statement calls attention to an operating procedure, practice, or condition, which, if not followed correctly, could result in injury or death to personnel. - Page 3 ENGLISH Use Only in Office-Type Indoor Setting The probe is designed to be used in office-type indoor environments. Do not operate the probe: In the presence of noxious, corrosive, flammable fumes, gases, vapors, chemicals, or finely-divided particulates. In environments where there is a danger of any liquid spilled on the probe. ...
-
Page 4: Terms And Symbols
ENGLISH Terms and Symbols The following symbols appear on the product or in its documentation: Direct voltage Both direct and alternating voltage Caution, possibility of electric shock Caution, see documentation for details Earth Ground Definitions Measurement Category II (CAT II) refers to local-level electrical distribution, such as that provided by a standard wall outlet or plug-connected equipment. -
Page 5: Compliance Statements
ENGLISH Compliance Statements EC Declaration of Conformity The product conforms to the applicable European Union requirements per IEC 61010-031:2015 Safety requirements for electrical equipment for measurement, control and laboratory use. Part 31: Safety requirements for hand-held probe assemblies for electrical measurement and test. EU RoHS Compliance The probe and accessories conform to the 2011/65/EU RoHS2 Directive. - Page 6 1 Introduction Overview The RS-SI 7005 active differential probe allows safe, accurate measurement between two voltage points where neither point is referenced to ground. The probe is designed for high sensitivity measurements up to 60MHz bandwidth. Compatible with oscilloscopes from all major manufacturers, the probe is exclusively powered by the included 9V power adapter.
-
Page 7: Using The Probe
ENGLISH 2 Using the Probe WARNING At the time of powering on the probe, the input leads must not be connected to an item to be tested. Never operate the probe with the case open. CAUTION This probe is used to carry out differential measurements between two points on the circuit under test. - Page 8 ENGLISH Getting Started Connect the BNC output connector to the vertical input of a general purposed oscilloscope. The oscilloscope must have a ground referenced. Connect power adapter. Select the proper attenuation ratio. When measuring signals below 3,5V, switch the attenuation ratio to x1 in order to get higher resolution and less noise ratio. For voltages up to 18V, set the attenuation ratio to x5 and for voltages up to 35V set the attenuation ratio to x10.
- Page 9 ENGLISH 3 Product Overview Probe Input – 2 x 4mm Plug Over Range Indicator (Red) Attenuation Selector Switch Power Indicator (Red) External Power Supply Probe Output BNC Connector...
-
Page 10: Specifications
ENGLISH 4 Specifications All specifications apply to the unit after a temperature stabilization time of 20 minutes over an ambient range of 25°C ± 5°C. RS-SI 7005 Bandwidth 60MHz @ x10 50MHz @ x5 15MHz @ x1 Rise Time 5,8ns @ x10... -
Page 11: Voltage Derating Curve
The derating curve of the absolute maximum input voltage in common mode is shown as follows: RS-SI Curve RS-SI 7005 Derating Curve 6 Cleaning This probe does not require any particular cleaning. If necessary, clean the case with a soft cloth. - Page 12 FOR MORE INFORMATIONS VISIT www.rs-components.com...
Need help?
Do you have a question about the RS-SI 7005 and is the answer not in the manual?
Questions and answers