Toshiba WT10-A Series User Manual page 81

Table of Contents

Advertisement

 
 
Article 14
 
 
 
Using this equipment in Japan
 
In Japan, the frequency bandwidth of 2,400MHz to 2,483.5MHz for second
generation low-power data communication systems such as this equipment
overlaps that of mobile object identification systems (premises radio station
and specified low-power radio station).
 
1. Important notice
 
The frequency bandwidth of this equipment may operate within the same
range as industrial devices, scientific devices, medical devices, microwave
ovens, licensed radio stations and non-licensed specified low-power radio
stations for mobile object identification systems (RFID) used in factory
production lines (Other Radio Stations).
1.
Before using this equipment, ensure that it does not interfere with any
of the equipment listed above.
2.
If this equipment causes RF interference to other radio stations,
promptly change the frequency being used, change the location of
use, or turn off the source of emissions.
3.
Contact an authorized TOSHIBA service provider if you have
problems with interference caused by this product to Other Radio
Stations.
 
2. Indication for Wireless LAN
 
The indication shown below appears on this equipment.
 
 
 
 
 
User's Manual
 
The low power radio-frequency devices shall not
influence aircraft security and interfere legal
communications;
If found, the user shall cease operating
immediately until no interference is achieved.
The said legal communications means radio
communications is operated in compliance with the
Telecommunications Act.
The low power radio-frequency devices must be
susceptible with the interference from legal
communications or ISM radio wave radiated
devices.
(1) (2) (3)(4)
(5)
7-9

Advertisement

Table of Contents
loading

This manual is also suitable for:

Wt8-b seriesEncore 2Wt8-bWt10-aEncore 2 series

Table of Contents