Table of Contents
Advertisement
After Operation
Charging the Battery Pack
Important:
The battery pack is not fully charged
when you purchase it. Before using the tool for
the first time, place the battery pack in the charger
and charge it until the LED display indicates the
battery pack is fully charged. Read all safety
precautions.
Important:
Charge the battery pack only in
temperatures that are within the appropriate
range; refer to
Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1.
Ensure that the vents on the battery and charger
are clear of any dust and debris.
Figure 16
1. Battery pack cavity
2. Battery pack venting areas 6. Handle
3. Battery pack terminals
4. Battery-charge-indicator
button
2.
Line up the cavity in the battery pack
with the tongue on the charger.
3.
Slide the battery pack into the charger until it is
fully seated
(Figure
4.
To remove the battery pack, slide the battery
backward out of the charger.
5.
Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator
Indicates
light
Off
No battery pack inserted
11).
5. LED indicators (current
charge)
7. Charger LED indicator
light
8. Charger venting areas
(Figure
16).
Green
Battery pack is charging
blinking
Green
Battery pack is charged
Red
Battery pack and/or battery charger is over or under
the appropriate temperature range
Red
Battery pack charging fault*
blinking
*Refer to
Troubleshooting (page 22)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
Cleaning Under the
Machine
Service Interval: After each use
Cleaning under the Machine Using
the Washout Port
For best results, clean the machine soon after you
have completed mowing.
1.
Move the machine onto a flat paved surface.
2.
Shut off the motor and wait for all moving parts
to stop before leaving the operating position.
3.
Lower the machine to its lowest cutting-height
setting. Refer to
g290533
(page
13).
4.
Wash out the area under the rear door where the
clippings go from the underside of the machine
to the grass bag.
Note:
Wash out the area with the
bag-on-demand (if equipped) in both the fully
forward and fully rearward positions.
5.
Attach a garden hose that is connected to a
16)
water supply to the washout port
17
for more
21).
Adjusting the Cutting Height
(Figure
17).
Advertisement
Table of Contents
