Miele G 7311 Operating Instructions Manual page 83

Problem
At the end of the pro-
gram, the alarm tone
sounds and the display
shows the following
message:

Fault F601
At the end of the pro-
gram, the alarm tone
sounds and the display
shows the following
message:
AutoDos maintenance re-
quired
The dishwasher does
not turn off at the end
of the program.
The dishware may not
be clean because an in-
sufficient amount of de-
tergent was dispensed.
The  AutoDos func-
tion is automatically de-
activated during the
program sequence.
Frequently Asked Questions
Possible cause and solution
There is a fault in the AutoDos.
 Turn the dishwasher off and back on again.
 Check whether the PowerDisk holder and the
PowerDisk have been installed correctly (see "Au-
tomatic dispensing/AutoDos" under "Detergent").
 Activate the  AutoDos function and start the pro-
gram again.
If the fault message appears again, there is a techni-
cal fault. You can continue to use your dishwasher by
deactivating AutoDos using the  AutoDos sensor
button and manually dispensing the detergent via the
detergent compartment.
 If you wish to use AutoDos again, contact Miele
Customer Service.
An empty PowerDisk has been inserted or the Auto-
Dos is blocked by residual detergent. Detergent
dosage is insufficient.
The  AutoDos function was automatically deacti-
vated.
 Turn the dishwasher off and back on again.
Multiple messages appear in the display.
 Clean the fill channel of the AutoDos (see "Clean-
ing the AutoDos" under "Detergent").
 Clean the lower spray arm (see "Cleaning the
spray arms" under "Cleaning and care").
 Select OK to confirm each message.
 Activate the  AutoDos function by confirming the
message AutoDos available
 Start the program again.
The program duration will be extended by up to
2.5 hours to flush out the AutoDos detergent outlet.
with OK.
83