Racing RAC26PBL Instruction Manual

Petrol blower vacuum shredder

Advertisement

Quick Links

ORIGINAL INSTRUCTIONS
INSTRUCTION MANUAL
RAC26PBL
Read carefully this manual before any use.
BUILDER SAS
32, rue Aristide Bergès –ZI 31270 Cugnaux - France
MADE IN PRC 2020
- 1 -

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RAC26PBL and is the answer not in the manual?

Questions and answers

Summary of Contents for Racing RAC26PBL

  • Page 1 ORIGINAL INSTRUCTIONS INSTRUCTION MANUAL RAC26PBL Read carefully this manual before any use. BUILDER SAS 32, rue Aristide Bergès –ZI 31270 Cugnaux - France MADE IN PRC 2020 - 1 -...
  • Page 2: Table Of Contents

    ORIGINAL INSTRUCTIONS CONTENTS SAFETY INSTRUCTIONS......................... 3 YOUR PRODUCT..........................7 ASSEMBLY.............................8 FILLING FUEL TANK ........................11 OPERATION..........................12 MAINTENANCE...........................14 DECLARATION OF CONFORMITY....................16 WARRANTY..........................17 PRODUCT FAILURE........................18 10. WARRANTY EXCLUSIONS......................19 - 2 -...
  • Page 3: Safety Instructions

    ORIGINAL INSTRUCTIONS 1. SAFETY INSTRUCTIONS WARNING: For your own safety, please read this manual before attempting to operate your new unit. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your blower before each use.
  • Page 4  Keep a safe distance from moving parts and never touch surfaces that become hot during use.  Wear a mask that filters out microscopic particles if your work generates dust, to avoid the risks associated with inhaling harmful dust. ...
  • Page 5 Maintenance and storage When the machine is stopped for servicing, inspection, or storage, or to change an accessory, shut off the power source and make sure that all moving parts have come to a complete stop. Allow the machine to cool before making any inspections, adjustments, etc.
  • Page 6 Guarantee noise emission Do not smoke; do not expose sparks and fire to the tool Attention, hot surface Intended use  This vacuum blower is intended to be used for the vacuuming and the blowing of leaves, dust, and similar little materials. It must not to be used for vacuuming and blowing water, chemical products, flammable material, metal or wood and others dangerous objects.
  • Page 7: Your Product

    ON/OFF switch Vacuum tube Trigger Housing of vacuum tube Handle Collector bag Fuel tank Collector bag adaptor Starter throttle control b. Technical data RAC26PBL Model Rated power 0.75 kW / 7000min¹ Idling speed 3000/min Max speed 7500/min Weight 5.73kg Air Speed:...
  • Page 8: Assembly

    3. ASSEMBLY For safety reasons, the product is equipped with safety contactors. It will start only when accessories are installed. It is strictly forbidden to modify safety system installed by the manufacturer. WARNING! You cannot use both functions simultaneously. A. BLOWER MODE -Assemble the two blowing tubes together.
  • Page 9 B. VACUUM MODE -Assemble the two suction tubes together. Open the cover on the side of the machine. Insert the suction tube and twist it slightly to lock it. -Open the collection bag and insert the adapter into it. Bring out the smaller part through the hole at the end of the bag.
  • Page 10 -Install the collection bag in the machine by inserting the end of the adapter into the connection hole of the collection bag. Tighten the screws to secure the installation. Screws To detach the collection bag, turn off the machine first, if it is on. Open the bag and empty it.
  • Page 11: Filling Fuel Tank

    4. FILLING FUEL TANK MOTOR FUEL: mix the petrol and oil at 40:1 only  Use fresh unleaded petrol. You must use 100% synthetic oil specifically made for heavily stressed two stroke engines.  Mix the petrol and oil in an approved container. Never mix fuel directly in the line trimmer fuel tank.
  • Page 12: Operation

    5. OPERATION a. Before starting Be sure that you have correctly completed the installation. Inspect the work area. Make sure there are no obstacles or dangerous debris that could damage the tool. b. Start/stop the machine NOTE: Starting the product differs depending on whether the engine is cold or warm.
  • Page 13 Push the choke lever down to the run position (warm start). The engine may start, or it may be required to pull on the recoil starter until the engine starts. Allow the engine to run idle for around 10 seconds to let it warm up. Pull the trigger to start the operation.
  • Page 14: Maintenance

    6. MAINTENANCE Follow these instructions to keep your machine in a good condition. A machine cleaned and in a good condition will give better operating results and preserves the life of the device. Regularly maintain your machine. WARNING! Do not use products that can damage the device (abrasive, corrosive, alcohols, steam cleaners, abrasive cloths, scrapers, etc.).
  • Page 15 c. Checking the spark plug  Check the spark plug every 10-15 hours of use.  Remove the spark plug cover.  Use the spark plug wrench to remove the spark plug, by turning it counter-clockwise.  Clean and adjust the spark plug gap to 0.6 - 0.7mm. ...
  • Page 16: Declaration Of Conformity

    ZI, 32 rue Aristide Bergès – 31270 Cugnaux - France Tel: +33 (0)5.34.502.502 Fax: +33 (0)5.34.502.503 Declares that the machines: PETROL BLOWER & VACUUM Model: RAC26PBL Serial No.: 20200713823-20200713892 The people name holding the technical file:M. Olivier Patriarca Have been designed in compliance with the following standards:...
  • Page 17: Warranty

    9. WARRANTY WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 2 years from the date of the original purchase. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. The manufacturer agrees to replace parts identified as defective by the designated distributor.
  • Page 18: Product Failure

    9. PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: a) Empty the fuel tank. b) Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine.
  • Page 19: Warranty Exclusions

    10. WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •...

Table of Contents