Hisense HYXE-VA01A Manual page 6

Model: HYXE-VA01A
Installation procedure
Insert the edge of the slotted screwdriver into the
groove at the bottom of the holding bracket, push
and turn the slotted screwdriver and then remove the
controller from the holding bracket.
(2) Attach the controller to the holding bracket and
connect the cable as follows.
A. In Case of Exposing Remote Control Cable
Fix the holding bracket
onto the wall with screws
(accessory)
B. When Using Switch Box
M4 Screws
(Field-Supplied)
Attach the remote control switch to the holding bracket. Be careful not to pinch the cable when attaching it.
(4)
Groove Part
Cable
JIS box
(Field-Supplied)
Groove Part for Removing Contronller
Approx. 6mm
Slotted Screw Driver
Attach the stopper to the
cable at the inside of the
draw-out hole.
Lead the cable with its
sheath peeled through
the groove.
Peel the insulation at
the end of the cable and
clamp the M3 solderless
Connect the terminals.
Bottom View