Hisense HYXE-VA01A Manual page 34

Model: HYXE-VA01A
2.9 Change indoor unit address
Address of target indoor unit (address number.)
Common mode (when indoor unit stopped)
Switch to site mode
When stopped, hold
Site mode selection
Press
to select Service Mode
enter address selection
RN
interface.
RN
RN
during connecting.
FUNCT and
or
OK to
RN
AH, indicating a successful change of refrigerant system.
Note:
It is a must to change it to a number within the normal range.
RN
If the address cannot be changed, "EE" will display. Please rectify the settings.
After change of address,
press Cancel to return to
common mode.
After change of address,
connecting process starts.
Indoor unit selection
RN
If an indoor unit without auto-address function is selected, [No
such function] will display.
re-energize indoor unit when icon on wireless
remote controller disappeared.
Note
After change of address in Step
Autoaddressing does not work properly.
Select address of the indoor unit
to perform auto-addressing
Press to select indoor unit
address
The sate of address of target unit
to change address number (target
to change refrigerant
,
, it is a must